Yamaha RX-797: ■ Remote control
■ Remote control: Yamaha RX-797
Table of contents
- CAUTION: READ THIS BEFORE OPERATING YOUR UNIT.
- CONTENTS
- FEATURES SUPPLIED ACCESSORIES
- CONTROLS AND FUNCTIONS Front panel
- CONTROLS AND FUNCTIONS
- Front panel display
- CONTROLS AND FUNCTIONS Rear panel
- CONTROLS AND FUNCTIONS Remote control
- CONTROLS AND FUNCTIONS
- Zone 2 remote control
- Installing batteries in the remote controls Using the remote controls
- CONNECTIONS Connecting speakers
- Connecting audio and video components
- Connecting the AM and FM antennas
- ■ Connecting the AM loop antenna
- Connecting the power supply cord
- Turning on and off this unit
- PLAYING AND RECORDING Playing a source
- PLAYING AND RECORDING
- Adjusting the tonal quality
- Recording a source
- Using the sleep timer
- Muting the sound output
- FM/AM TUNING Automatic tuning
- Manual tuning
- Automatic preset tuning
- FM/AM TUNING
- FM/AM TUNING Manual preset tuning
- FM/AM TUNING Selecting preset stations Exchanging preset stations
- RADIO DATA SYSTEM (EUROPE MODEL ONLY) Receiving Radio Data System Changing the Radio Data System stations mode
- PTY SEEK function
- EON function
- ADVANCED SETUP Changing the ADVANCED SETUP menu parameters
- Switching the remote control ID
- ZONE 2 Connecting the Zone 2 components
- Controlling Zone 2
- REMOTE CONTROL FEATURES Control area
- Controlling other components
- Setting remote control codes
- TROUBLESHOOTING ■ General
- ■ Tuner
- ■ Remote control
- SPECIFICATIONS
- LIST OF REMOTE CONTROL CODES

TROUBLESHOOTING
■ Remote control
See
Problem Cause Remedy
page
The remote control
Wrong distance or angle. The remote control will function within a maximum
does not work nor
range of 6 m (19.7 ft) and no more than 30 degrees
10
function properly.
off-axis from the front panel.
Direct sunlight or lighting (from an
Reposition this unit.
inverter type of fluorescent lamp, etc.) is
—
striking the remote control sensor of this
unit.
The batteries are weak. Replace all batteries.
10
The remote control ID and this unit’s ID
Switch the remote control ID or this unit’s ID.
9,32,33
do not match.
The remote control code was not correctly
Try setting another code of the same manufacturer
set.
using “LIST OF REMOTE CONTROL CODES” at
38
the end of this manual.
Even if the remote control code is
Use the supplied remote control for the components.
correctly set, there are some models that
—
do not respond to the remote control.
INFORMATION
ADDITIONAL
English
41

