Skil 0790 RA: PERSONALSAFETY INTRODUCTION ELECTRICAL SAFETY TECHNICAL DATA 1 TOOL ELEMENTS 2 SAFETY GENERAL BEFORE USE
PERSONALSAFETY INTRODUCTION ELECTRICAL SAFETY TECHNICAL DATA 1 TOOL ELEMENTS 2 SAFETY GENERAL BEFORE USE: Skil 0790 RA
Table of contents
- PERSONALSAFETY INTRODUCTION ELECTRICAL SAFETY TECHNICAL DATA 1 TOOL ELEMENTS 2 SAFETY GENERAL BEFORE USE
- DURING USE EXPLANATIONOFSYMBOLSONTOOL MAINTENANCE / SERVICE USE TROUBLESHOOTING
- ENVIRONMENT DECLARATION OF CONFORMITY NOISE/VIBRATION

6
• Store the tool indoors in a dry and locked-up place, out
of reach of children
PERSONALSAFETY
Garden blower/vacuum 0790
• This tool is not intended for use by persons (including
children) with reduced physical, sensory or mental
INTRODUCTION
capabilities, or lack of experience and knowledge, unless
they have been given supervision or instruction
• This tool has been designed for blowing/collecting as well
concerning use of the tool by a person responsible for
as vacuuming/shredding dry leaves and other dry garden
their safety
rubbish such as grass and twigs
• Ensure that children do not play with the tool
• This tool is intended for domestic use only and is not
• Neverallowchildrentousethetool
designed to be used under wet conditions
• Never blow debris in the direction of bystanders
• This tool is not intended for professional use
• Always wear long trousers, long sleeves and sturdy
• Readthisinstructionmanualcarefullybeforeuse
shoes when operating the tool
andsaveitforfuturereference3
• Wear protective gloves, safety glasses, close-tting
• Payspecialattentiontothesafetyinstructionsand
clothes and hair protection (for long hair)
warnings;failuretofollowthesemayresultin
• Wear a dust mask when working in a dusty environment
seriousinjury
ELECTRICAL SAFETY
• Check whether the packaging contains all parts as
• Always check that the supply voltage is the same as the
illustrated in drawing 2
voltage indicated on the nameplate of the tool (tools with
• When parts are missing or damaged, please contact your
a rating of 230V or 240V can also be connected to a
dealer
220V supply)
• Connect the tool via a fault current (FI) circuit breaker
TECHNICAL DATA 1
with a triggering current of 30 mA maximum
• Use completely unrolled and safe extension cords with a
TOOL ELEMENTS 2
capacity of 16 Amps (U.K. 13 Amps)
A Lower blower/suction tube
• Only use an extension cord which is intended for outdoor
B Upper blower/suction tube
use and equipped with a watertight plug and coupling-
C Collection bag
socket
D Shoulder strap
• Only use extension cords with a maximum length of 20
E Cord restraint
metres (1,5 mm²) or 50 metres (2,5 mm²)
F On/o switch
• Always switch o tool and disconnect plug from power
G Switch for selecting operating mode
source if the power supply cord or the extension cord is
H Supporting wheels
cut, damaged or entangled (donottouchthecord
J Ventilation slots
beforedisconnectingtheplug)
K Main handle
• Protect the (extension) cord from heat, oil and sharp
L Guide handle
edges
M Fastening screws (4)
• Never use the cord for carrying, pulling or unplugging the
N Vacuum opening
tool
P Blower opening
• Inspect the cord periodically and have it replaced by a
Q Storage rail (screwsnotsupplied)
qualied person, if damaged
R Storage hook
• Inspect the extension cord periodically and replace it, if
damaged (inadequateextensioncordscanbe
dangerous)
SAFETY
• Do not use the tool if the switch does not turn it on and
GENERAL
o; always have a damaged switch repaired by a qualied
• Only use the tool in daylight or with appropriate articial
person
lighting
BEFORE USE
• Only use the tool when completely assembled
• Be familiar with the controls and the proper use of the tool
• Do not use the tool on wet lawns and when the materials
• Check the functioning of the tool before each use and, in
to be blown/vacuumed are wet
case of a defect, have it repaired immediately by a
• Do not blow at or towards hot, ammable or explosive
qualied person; never open the tool yourself
materials
• Beforeuse,thoroughlyinspecttheareawherethe
• Do not vacuum hot, ammable or explosive materials
toolistobeusedandremoveallsolidobjectsthat
• Never operate the tool in the direct vicinity of persons
coulddamagetheshreddingmechanismwhen
(especially children) and animals
vacuuming(suchasstones,brokenglass,piecesof
• The user is responsible for accidents or hazards
metal)
occurring to other people or their property
• When vacuuming, never use the tool without the
• Always disconnect plug from power source
collection bag in place
- whenever leaving the tool unattended
• Regularly check the collection bag for wear or damage
- before clearing jammed material
• Replace worn of damaged parts
- before checking, cleaning or working on the tool
- whenever the tool starts vibrating abnormally

