Skil 0760 RA: INTRODUCTION PERSONALSAFETY TECHNICAL DATA 1 TOOL ELEMENTS 2 WATERSUPPLY SAFETY GENERAL ELECTRICAL SAFETY

6

• Only use the tool when the ambient temperature is

between 0°C and 40°C

• Startworkingonlywhentoolandoperating

High-pressure washer 0760

equipmentareinperfectconditionandsafeto

operate

INTRODUCTION

• Be aware of the kickback forces that occur when starting

the high-pressure washer; hold hand gun and spray lance

• This tool has been designed for cleaning areas and

rmly and take a secure stance

objects outside the house, vehicles and boats

• Never clamp the trigger in position during operation

• This tool is intended for domestic use only and is not

• Neverdirectthewaterjettowardsotherpeople,

designed to operate with water from sources other than a

animals,liveelectricalequipmentorthetoolitself4

watertap

• Never leave the tool unattended while the motor is

• This tool is not intended for professional use

running

• Readthisinstructionmanualcarefullybeforeuse

• Do not operate the tool in potentially explosive locations

andsaveitforfuturereference3

• Alwaysswitchofftool,disconnectplugfrompower

• Payspecialattentiontothesafetyinstructionsand

source,andensurethereisnowaterpressurein

warnings;failuretofollowthesemayresultin

toolandhandgunbeforeadjusting,cleaningor

seriousinjury

changingaccessories

• Check whether the packaging contains all parts as

PERSONALSAFETY

illustrated in drawing 2

• This tool is not intended for use by persons (including

• When parts are missing or damaged, please contact your

children) with reduced physical, sensory or mental

dealer

capabilities, or lack of experience and knowledge, unless

they have been given supervision or instruction

TECHNICAL DATA 1

concerning use of the tool by a person responsible for

Working pressure (P) 7 MPa

their safety

Maximum working pressure (Pmax) 10 MPa

• Ensure that children do not play with the tool

Inlet pressure 0 - 0,6 MPa

• Wear suitable protective clothing to protect against

splashing water

• Donotusethetoolwithotherpersonsinthevicinity

TOOL ELEMENTS 2

unlesstheywearprotectiveclothing

A Trigger lock

• Do not spray materials containing asbestos and other

B Trigger

materials which contain substances which are hazardous

C Inlet connector

to your health

D Water inlet

• Only clean tyres/tyre valves from a minimum distance of

E Water lter

30 cm to prevent damaging them (damaged vehicle tyres

F Mains switch

may lead to fatal accidents)

G Spraying nozzle

• Donotdirectthewaterjetagainstyourselforothers

H Detergent bottle

inordertocleanclothesorfootwear

J Detergent nozzle

WATERSUPPLY

K Spray lance

• Onlyusethehigh-pressurehoseandcoupling

L Hand gun

suppliedwiththetool

M Cleaning needle

• Replace a damaged high-pressure hose immediately

N Storage rail (screwsnotsupplied)

(with identical specications)

P Storage strap (2)

• Do not kink or drive a motor vehicle over the high-

Q High-pressure hose

pressure hose

R Water outlet

• Do not expose the high-pressure hose to sharp edges or

S Ventilation slots

corners

T Connection for storage straps

• Ensure that all connecting hoses have properly sealed

joints

SAFETY

• Beawarethatthesprayedwatergeneratedbythe

GENERAL

toolisnotdrinkable

• Use the tool and its accessories in accordance with this

• According to the applicable regulations, the tool must

instruction manual and in the manner intended for the

never be used on the drinking water net without a system

tool; use of the tool for operations, dierent from those

separator 5; use a suitable system separator as per EN

normally expected to be performed by the tool, could

12729 type BA

result in a hazardous situation

ELECTRICAL SAFETY

• Neverdrawinsolvent-containingliquids,undiluted

• Always check that the supply voltage is the same as the

acidsorsolvents(e.g.petrol,paintthinners,heating

voltage indicated on the nameplate of the tool (tools with

oil); these liquids produce a highly ammable, explosive

a rating of 230V or 240V can also be connected to a

and toxic sprayed vapour and they also corrode the tool

220V supply)

components

• Connect the tool via a fault current (FI) circuit breaker

with a triggering current of 30 mA maximum