Siemens DE2427555: Fault Cause Solution Who
Fault Cause Solution Who: Siemens DE2427555
Table of contents
- Safety information Your new appliance Operating the continuous-flow heater
- Desired temperature Changing the desired temperature Wellness program Starting wellness program 1
- Starting wellness program 2 Ending wellness program 1 or 2 Changing the wellness program temperature
- Child protection Activating child protection Deactivating child protection
- Conserving energy and water at the touch of a button
- The meaning of display indications
- Using the appliance after switching off the water supply Start-up after power failure Cleaning Customer Service
- A fault, what to do? Fault Cause Solution Who
- Fault Cause Solution Who
- Disposal Guarantee
en
Fault Cause Solution Who
E02 No thermostatic premixer
Install a thermostatic premix-
Customer
available. The supply tem-
er in the domestic supply.
perature to the continuous-
flow heater is higher than
55 °C (e. g. due to pre-
warmed water supplied
from a solar water heater).
The supply temperature to
The thermostatic premixer
the continuous-flow heater
in the domestic supply must
is higher than 55 °C (e. g.
be set accordingly to lower
due to pre-warmed water
temperatures.
supplied from a solar water
heater).
E03–E04 Temperature sensor
Please contact customer
Customer
defective
service.
Service
E05–E07 Electronic malfunction Please contact customer
Customer
service.
Service
E08 Frost damage
The appliance is defective!
Customer/
The water supply sensor
Switch off the water supply
Servicing
measures a temperature of
immediately and disconnect
expert
≤ 0 °C.
the appliance from then elec-
trical supply (also refer to the
safety instructions). Please
contact customer service.
E09 Temperature sensor/
Please contact customer
Customer
electronics defective
service.
Service
E10–E11 Bubble detection triggers.
Disconnect the appliance
Customer/
from the electrical supply.
Servicing
Open the warm water tap ful-
expert
ly for venting purposes and
flush out the appliance thor-
oughly for 1 minute. Switch
the power back on again.
E12–E13 Electronic malfunction Please contact customer
Customer
service.
Service
If the fault could not be eliminated, please call customer service.
20
