Binatone SI-4040: Burst of steam in a vertical position Spray Auto stop

a click.

To ease ironing of dense cotton, linen and upholstery articles

use the steam burst button (8): engagement of the button (8)

during the ironing process generates an extra burst of steam from

the sole plate to help remove stubborn creases.

Burst of steam in a vertical position

This function helps to freshen the appearance of curtains, jack-

ets, coats, etc. To use this function, take the following steps:

X Follow instructions in paragraph 1-4 of the section “Opera-

tion instructions”. While selecting the temperature setting,

put the temperature control knob (10) into the “Max” posi-

ENGLISH

tion.

X While holding the iron in a vertical position, aim its sole plate

towards the articles to be ironed and push the steam burst

button (8) to produce a directional strong burst of steam from

the sole plate. Push the button several times with 5-7 seconds

intervals until the article is fully refreshed. If during the process

your water tank (5) runs out of water, disconnect the appli-

ance from the mains outlet, wait till it cools down, refill the tank

and plug the appliance back into the power supply and con-

tinue the process.

Spray

Using the water spray (7) will help when ironing details of the

article (cuffs, trimmings, plackets, etc) or clothes, which demand

“ ” (low temperature) ironing, when steam ironing is not possible.

Push the button several times to moisten the material.

Auto stop

For safety reasons, your iron will automatically stop heating if

it’s left:

X upright for 8-15 minutes, or

X flat for 10-30 seconds.

The Auto shut off pilot light (16) will flash. The iron will heat up

again when you move it and the auto safe light will go out.

X To deactivate automatic shut off, stand iron on heel or shake

gently, then the iron will switch on again.

5. When you have finished cleaning or ironing, do not forget to

switch the iron off by putting the steam control knob (9) into

the “0” position, the temperature control knob (10) – into

the “Min” position and unplugging the appliance from the

mains supply outlet.

7