Binatone MEJ-1791: SPECIAL SAFETY MEASURES

cracks etc.), get it checked by the nearest authorized service

center.

SPECIAL SAFETY MEASURES

X Do not touch hot surfaces of the appliance. Do

not touch outer surfaces of the kettle with the ex-

ception of the heat insulated handle, when water

is boiling or with hot water inside the device.

X Allow kettle to cool prior to its cleaning and

storing.

ENGLISH

X Disconnect the appliance from the electricity

supply during prolonged storage, prior to filling it with water/

emptying it or prior to moving it from one place to another.

X The appliance shall always operate on heat resistant, horizon-

tal and dry surfaces.

X To avoid being burnt by hot vapor always close the lid tightly

prior to switching the device on. Avoid exposure to hot vapor.

WARNING! Never open the lid immediately before

of after boiling temperature is reached.

X Prior to switching the kettle on make sure the water level stays

not lower than the minimal mark and not higher than the

maximum mark at the water gauge. The kettle is protected

against overheating if switched on without water. In case of

overheating, an automatic safety cut out device will switch it off

in case of absence or excessively little quantity of water inside

the kettle. If the safety device is activated, allow the kettle to

cool down prior to boiling water in it. The kettle would not

switch on if it’s too hot. WARNING! Frequent switching

the kettle on without water might result in the safety

device failure, that is why prior to switching the kettle

on always check the water level. Always make sure

the water level in the kettle is not too low.

X Always switch the kettle off prior to lifting it from the base.

X Use the kettle only with the supplied base.

X Do not fill the hot kettle with cold water or vice versa. WARN-

ING! Avoid sharp temperature fluctuations when fill-

ing the kettle with water.

X Connect the device only to the electrical supply with protec-

tive earthing. If your socket has no protective earthing, con-

tact a qualified specialist. Do not modify the plug and do not

use cord adapters. WARNING! Electric hazard might

occur if the kettle is plugged into the unearthed power

supply.

X Clean the heating element of the kettle more often to descale

it. Remember that use of the heavily scaled kettle might result

in its malfunction. WARNING! Descale the kettle using

only specially designed cleaning agents.

X Before turning the kettle on, make sure that the lid is closed;

otherwise the kettle will not turn off after boiling.

X After use of the appliance, the base of the kettle might be wet.

It is a normal condition of operation, caused by escaping steam,

used to activate the kettle’s automatic turning off function.

X Do not tilt the filled kettle backwards, since water can spill

5