Sigma ELECTRONIC FLASH EF-610 DG SUPER SO-ADI (ソニー用): TTL AUTO FLASH

TTL AUTO FLASH

In the TTL AUTO Mode, the camera will control the amount of flash lighting, to get the appropriate

exposure for the subject.

◆ Depending on the camera model and lens combination, TTL Flash procedure varies. Please see the

below chart. (In all combinations, TTL will be displayed on the LCD)

D-SLR / Maxxum 70, 50, 7, 5, 4, 3

D

17

Maxxum 9

nax 7D, 60, 40, 7, 5, 4, 3L

D

Other Camera Models

nax 9

D type Lens ADI metering Pre-flash metering Ordinary TTL metering

Non-D type lens

Pre-flash metering Pre-flash metering Ordinary TTL metering

1. Set the camera’s exposure mode to

P

Mode.

2. Turn on the power switch of the flash, the TTL mark will appear

on the LCD panel and the flash will start charging.

◆ With D-SLRs, please make sure that indicator is on. If the

indicator is off, press the

+

or

–

button and make the

indicate indicator appear on the LCD panel, otherwise

exposure will not be correct.

3. Focus on your subject.

4. Check that the subject is located within the effective flash distance range, indicated on the LCD

panel of the flash unit.

5. Press the shutter button, after the flash is fully charged.

◆ When the camera receives the appropriate exposure, the TTL mark on the flash’s LCD panel will

appear for 5 seconds. If this indication does not appear, the flash illumination is not sufficient for that

situation. Please re-take the picture, at a closer distance.

◆ The AF Auxiliary Light will turn on automatically if you focus on a subject in a dark area. The effective

range of the AF Auxiliary Light is up to about 0.7meter to 9meter (2.3-29.5 feet).

◆ Please note that when the camera is set to M mode, the flash will be set to the mode settings last

used.

◆ When the flash is fully charged, the flash mark will appear in the camera viewfinder. If the shutter is

released before the flash is fully charged, the flash will not fire, and the camera will take the picture

at a slow shutter speed as if by ambient light only.

USING FLASH IN OTHER CAMERA MODES

Shutter Speed Priority Setting

When you set the desired shutter speed, the camera will select the appropriate aperture value. You

cannot choose shutter a speed faster than the camera’s sync speed. Fill flash is used when this mode

is selected.

Aperture Priority Setting

By selecting the A mode, after you select the desired aperture the camera will set the appropriate shutter

speed for the background exposure. Fill flash is used when this mode is selected.

When used with M Mode

You can set the desired shutter speed and aperture value. You can set the shutter speed from top sync

speed to bulb.

◆ The fill flash is used when this mode is selected.

◆ If you adjust the exposure according to the exposure meter indication, the camera will work as for

Daylight synchronization flash or slow synchronization.

LIMITS OF CONTINUOUS SHOOTING

To prevent overheating of the flash’s circuitry, please do not use your Flash unit for at least 10minutes

after using the number of flash exposures, shown in the below table have been made in quick succession.