Sigma ELECTRONIC FLASH EF-610 DG SUPER SO-ADI (ソニー用): SLAVE FLASH

Off-Camera Flash Setting

9. If the Off-Camera Flash is EF-610 DG SUPER SO-ADI, please process the same setting of B-1

Off-Camera Flash Setting.

◆ If the Off-Camera Flash is EF-530 DG SUPER SO-ADI, please refer to the instruction manual of

EF-530 DG SUPER SO-ADI.

◆ If the Off-Camera Flash is EF-530 DG SUPER SO-ADI, the channel number can be set only from C1

to C3.

SLAVE FLASH

NORMAL SLAVE FLASH

Even if the EF-610 DG SUPER SO-ADI is not attached to the camera body, you can fire the flash by

using the camera’s built-in flash or another flash unit

1. Attach the flash unit to the camera’s hot shoe.

2. Set the camera’s exposure mode to the desired mode. If you use A or M mode, set the desired

aperture value also.

3. Turn on the flash unit. Then press the shutter button half way.

◆ Now, the aperture value and film speed are automatically

transmitted to the flash unit.

4. Remove the flash unit from camera.

5. Press the MODE button and select the / (Slave)

mode.

6. Press the SEL button several times to make the flash output

amount indicator blink.

7. Press the + button or – button to set the flash output amount.

◆ Determine the appropriate flash power by setting the distance indicator on the LCD panel to coincide

as closely as possible, with the actual distance from the slave flash to the subject. If the actual

distance is out of range, you need to change the aperture value.

◆ You can set the film speed or aperture value on the flash unit manually, if desired.

a. For the film speed … Press the MODE to select the ISO, then press the SEL button to make the

indicator blink. Press the + button or – button and set the desired film speed, then press the SEL

button once again.

b. For the aperture value … When the flash unit is set to the Slave mode, press the SEL button to

make the indicator for the aperture value blink, and press the + button or – button to set the

desired aperture value. Then press the SEL button.

8. Press the SEL button several times to make the display stop blinking.

9. Place the slave unit in the desired location. Do not place the slave unit within the Picture area.

10. After you confirm that all flash units are fully charged, press the shutter button to take the picture.

◆ If you are using a SONY brand flash unit , or the camera’s built-in flash TTL function on your camera,

and the EF-610 DG SUPER SO-ADI flash unit as a slave unit, please do not use ADI,DI function, as

the monitor pre-flash may cause the slave to fire prematurely.

◆ When the EF-610 DG SUPER SO-ADI is fully charged, the AF Auxiliary Light will blink.

◆ The flash will not fire if the EF-610 DG SUPER SO-ADI is attached to the camera body while it is in

the Slave Mode setting.

DESIGNATED SLAVE FLASH

If you use two or more EF-610 DG SUPER SO-ADI flash units, you can designate which flashes will

fire together by using the channel settings. In this mode, one flash unit will be used as the Slave

Controller and the others for firing as Slaves.

23