Siemens TK 54001: Settings and displays

en

6 Standby button a

●Determinethewaterhardnesswiththe

Button a switches on the appliance or

enclosed test strip.

switches it to stand-by mode. When button

a is pressed, the appliance heats up and

e.g. = Hardness 2

buttonaasheswhiletheapplianceheats

up and is rinsed. When the buttons 4, 5, a

●Switchthedevicetostandby.

and h light up and one, two or three beans

●Holddownthesteambuttonh for at

(depending on the setting) appear on the

least 3 seconds. The number of service

display, the appliance is ready for operation.

buttons 4, 5, a, h that light up indicate

The appliance will not be rinsed if:

the selected water hardness.

– it was still warm when switched on, or

●Pressthesteambuttonh repeatedly

– coffee was not discharged before it was

until the correct number of buttons is lit.

switched to “stand-by“ mode,

●Pressbuttona once. The selected

or

number of service buttons should light

– steam was discharged shortly before it

upbriey;thisindicatesthatthedesired

was switched off.

water hardness setting has been saved

successfully.

7 Steam generation button h

Ifawaterlter(specialaccessory)isused,

Button h generates steam for foaming or

the water hardness should be set to 1.

warming.

Note: If no button is pressed within 90

8 Steam dispensing dial

seconds, the appliance switches to stand-

Hot water or steam can be dispensed by

by mode without saving the new settings.

turning the dial to hot water g or steam h.

In this case, the previous water hardness

To dispense steam, the steam generation

setting is retained.

button hmustbepressedrst(see“Steam

for foaming milk“).

Thersttimealterisusedorafter

changingthelter,theapplianceneedsto

be cleaned.

●Fillthewatertankuptothe0.5lmark.

Settings and displays

●Placeasuitablecontainer(approx.0.5

Setting the water hardness

litres) under the nozzle 9.

It is important that the water hardness be

●Turnthedial8 to g/h.

set correctly, so that the appliance indicates

●Ifnowatercomesoutofnozzle9, turn

accurately when the descaling programme

the dial back to O.

should be run. The factory setting is a water

●Fillthewatertankandwaterpipes(see

hardness of 4. You can check the water

section “Switching on the appliance”).

hardness using the enclosed test strip or by

asking your local water supplier.

Adjusting the grinding unit

Sliding switch 16 adjusts the degree of

grinding,fromcoarsetone.

Degree Water hardness

German (°dH) French (°fH)

Warning

1

1-7

1-13

Adjust the grinding unit only while it is

2

8-15

14-27

running! Otherwise the appliance may be

3

16-23

28-42

damaged.

4

24-30

43-54

●Pressthecoffeedispensingbutton4.

13