Siemens DE18401: Fault Disposal Guarantee

12

en

Fault

Cause

Solution

Who

Winter operation:

The desired water temperature 

leaving the tap is no longer 

reached.

The supply temperature has 

reduced.

Reduce the water flow on the taps 

until the desired water temperature 

is reached.

Customer

The appliance does not start 

(heat), no water flows.

Power failure or initial start-up.

Starts rinsing: 

Open the warm water tap and 

 allow water to flow for at least 

1 minute (flow-rate at least 6 litres 

per minute). Only then (for safety 

reasons) will the appliance begin 

to heat.

Should the appliance not start 

because of a reduced flow-rate, 

 remove the perlator, shower head 

or similar before start and repeat 

the process.

Customer

If the fault could not be eliminated, please call customer service.

Disposal

This appliance is labelled in accordance with Euro-

pean Directive 2002/96/EG concerning used elec-

trical and electronic appliances (waste electrical 

and electronic equipment – WEEE). 

The guideline determines the framework for the 

return and recycling of used appliances as applica-

ble throughout the EU.

Please ask your specialist retailer about current 

disposal facilities.

Guarantee

The guarantee conditions for this appliance are as defined by 

our representative in the country in which it is sold.

Details regarding these conditions can be obtained from the 

dealer from whom the appliance was purchased. The bill of 

sale or receipt must be produced when making any claim un-

der the terms of this guarantee.

Subject to change without notice.