Panasonic SB-TP100: Notes

Notes: Panasonic SB-TP100

background image

RQT8573

20

ENGLISH

ESP

AÑOL

Notes

Speaker impedance and allowed input

SB-FS100 / SB-PC100

Impedance

Ω

Input power

100 W (RATED)

  

The only receivers or ampli

fi

 ers you should connect to these speakers 

are those whose rated output does not exceed the above 

fi

 gures.

Using a receiver or ampli

fi

 er with higher ratings than listed above can 

cause abnormal sounds to occur because of excessive input, damage 

to the receiver or speakers, and 

fi

 re. If equipment is damaged in any 

way or unexpected trouble occurs during playback, unplug the system 

from its outlet and call a serviceman for help.

Protection circuitry 

(SB-FS100 / SB-PC100)

These units incorporate protection circuitry to protect them from dam-

age caused by excessive input or abnormal signals; when excess input 

is detected, input is automatically interrupted.

If sound is interrupted...

1. Reduce the volume of the receiver (or ampli

fi

 er).

2. Check the sound source and connections for any problems.

If there is no problem, the protection circuitry will reset in a few 

minutes.

After the protection circuit is reset...

Take care not to increase the receiver’s volume too high.

Excessive input

You can damage your speakers and shorten their life span 

if you keep the volume high over extended periods.

Reduce the volume in the following cases to avoid dam-

age :

• When playing distorted sound. 

• When the speakers are receiving howling from a microphone or 

record player, noise from FM broadcasts, or continuous signals from 

an oscillator, test disc, or electronic instrument. 

• When adjusting the sound quality. 

• When turning the ampli

fi

 er on or off.

Other notes

If irregular coloring occurs on your television :

These speakers are designed to be used close to a television, but 

the picture may be affected with some televisions and set-up com-

binations.

If this occurs, turn the television off for about 30 minutes.

The television’s demagnetizing function should correct the problem. If 

it persists, move the speakers further away from the television.

The active subwoofer (SB-WA101) is not magnetically 

shielded.

Do not place it near a television set, PC, or other device that 

is affected by magnetic 

fi

 elds.

Keep magnetized items away.

Magnetized cards, bank cards, commuter passes, etc., can be dam-

aged if placed too closed to the speaker magnets. Clocks may also 

be affected.

Avoid locations such as described below :

• In direct sunlight

• Near heating appliances or other sources of heat 

• Where the humidity is high

Maintenance

Clean these units with a soft, clean, dry cloth.

• Never use alcohol, paint thinner, or benzine to clean these units. 

•  Before using chemically treated cloth, read the instructions that came 

with the cloth carefully.

Notas

Impedancia del altavoz y potencia 

de entrada 

SB-FS100 / SB-PC100

Impedancia

Ω

Potencia de entrada

100 W (RATED)

Los únicos receptores o ampli

fi

 cadores que deberá conectar a estos 

altavoces son aquellos que cuya salida nominal no exceda las cifras 

de arriba.

Al usar un receptor o un ampli

fi

 cador con características nominales 

superiores a las indicadas arriba se pueden producir ruidos anormales 

debido a la entrada excesiva, el receptor o los altavoces se pueden 

estropear, y además se puede producir un incendio. Si el equipo es 

dañado de alguna manera o un problema inesperado ocurre durante 

la reproducción, desenchufe el sistema y llame a su distribuidor para 

que envíen una persona que le ayude.

Circuito de protección 

(SB-FS100 

/

 SB-PC100)

Estas unidades incorporan un circuito de protección para protegerlos 

de daños causados por una entrada excesiva o señales anormales; 

cuando una entrada excesiva es detectada, la entrada es automáti-

camente interrumpida.

Si el sonido se interrumpe...

1. Reduzca el volumen del receptor (o ampli

fi

 cador).

2. Veri

fi

 que si hay problemas en la fuente de sonido y las conexiones. 

Si no hay problemas, el circuito de protección se reajustará en unos 

pocos minutos.

Después de que el circuito de protección sea reajusta-

do... 

Cuídese de no incrementar demasiado el volumen del receptor.

Entrada excesiva

Si reproduce el sonido con niveles altos durante períodos 

de tiempo prolongados podrá estropear sus altavoces y 

reducir su duración.

Para evitar daños, reduzca el volumen en los casos 

siguientes:

 Cuando reproduzca sonido distorsionado.

 Cuando los altavoces reciban aullido procedente de un micrófono 

o giradiscos, ruido de emisiones de FM o señales continuas proce-

dentes de un oscilador, disco de prueba o instrumento electrónico.

 Cuando ajuste la calidad del sonido.

 Cuando encienda o apague el ampli

fi

 cador.

Otras notas

Si se producen colores irregulares en su televisor:

Estos altavoces han sido diseñados para ser utilizados cerca de un 

televisor, sin embargo, con algunos televisores y combinaciones de 

instalación es posible que la imagen se distorsione.

Si ocurre esto, apague el televisor durante unos 30 minutos.

La función de desmagnetización del televisor deberá corregir el 

problema. Si persiste el problema, separe más los altavoces del 

televisor.

El altavoz de subgraves activo (SB-WA101) no está pro-

tegido magnéticamente.

No lo coloque cerca de un televisor, PC u otro dispositivo que sea 

afectado por los campos magnéticos.

Aleje los objetos magnetizados.

Las tarjetas magnetizadas, las tarjetas de bancos, los pases de vi-

ajeros, etc., pueden estropearse si se dejan demasiado cerca de los 

imanes de los altavoces. Los relojes también pueden ser afectados.

Evite ubicaciones como las indicadas a continuación:

• Expuestas a los rayos solares directos

• Próximas a dispositivos de calefacción u otras fuentes de calor 

• Donde la humedad sea excesiva

Mantenimiento

Limpie estas unidades con un paño blando, limpio y seco.

•  No utilice nunca alcohol, diluyente de pintura ni bencina para limpiar 

estas unidades.

• Antes de utilizar un paño impregnado químicamente, lea con aten-

ción las instrucciones suministradas con la unidad.

RQT8573-12lang.indb   20

RQT8573-12lang.indb   20

07/02/2006   18:30:22

07/02/2006   18:30:22