Rowenta OPIO ES3200: GB 4. BEFORE USING FOR THEFIRST TIME

13

GB 4. BEFORE USING FOR THE FIRST TIME

Before using your espresso machine for the

first time, clean all the accessories in soapy

water and dry them.

Rinse them as follows:

Open the lid (a) and remove the water tank

using the handle

(fig. 1)

.

Fill the tank (b) with cold water and place it

firmly on the machine, making sure it is firmly

in place, and close the lid 

(fig. 2 et 3).

nsert and turn the filter holder to the right

(fig 7).

Place a container of sufficient volume under

the filter holder. 

Turn the appliance on 

(fig. 4).

The "On/Off" light stops (g) stops flashing and

turns on.

Without waiting, turn the Coffee function

selector (h) to the 

position (h2) and let all

the water in the tank drain out 

(Fig. 5)

. During

this first use, the system must fill up and the

water does not flow immediately. 

If necessary, to empty the water from the

container, you can interrupt the flow by turning

the coffee function selector switch (h) to the

position (h1).

5. MAKING AN ESPRESSO

WITH ESPRESSO GROUND COFFEE:

- Fill the tank with cold water and place it firmly

on the machine, making sure it is firmly in

place, 

(fig. 1, 2 and 3)

.

- Place the filter (c.1) for 1 cup or the filter (c.2)

for 2 cups in the filter holder (j) 

(fig. 6)

.

- using the measuring spoon (d), fill the filter

with ground coffee. 

(1 dose = 1 cup, 2 doses = 2 cups) in the filter.

(fig 8, 9)

- Remove the coffee which remains around the

filter. 

- Insert and turn the filter holder to the right

(fig 7).

- Place one or two espresso cups under the

filter holder.

As soon as the device reaches the required

temperature, the coffee light (h3) stops

flashing.

- Turn the coffee function selector switch (h) to

the position 

(h2).

- When the cups are filled to your liking, turn

the switch to the 

logo position (h1).

- Remove the filter holder by turning it to the

left .

- To eject the spent coffee, turn the filter holder

over, holding the filter by the tab so that the

spent coffee does not fall out 

(fig 11).

For the best results, we recommend that you

preheat the accessories (filter holder, filter and

cups) following the steps above without using

ground coffee.

WITH SOFT PODS:

Besides coffee, this machine can also work

with espresso ground coffee pods.

There are two types of espresso pods

commercially available:

- Soft pods (71mm) for filter (C1).

- ESE pods .S.E. (44 mm) for the specific filter

(c3).

- Place the espresso pod in the filter (c1). 

Be sure to place all the paper inside the filter

holder, to avoid leaks and get a good result in

the cup. 

- Insert and turn the filter holder to the right

(fig.7).

- Then follow the procedure for preparing an

espresso with espresso ground coffee.

6. STEAM FUNCTION AND  MAKING A CAPPUCCINO

You can use the steam nozzle to froth milk.

Foamy milk is obtained by placing a container

of very fresh, cold milk under the steam nozzle.

It can then be added to an espresso to make a

cappuccino.

To avoid the formation of excessive pressure

inside the filter, you should remove the filter

holder before using steam.

SYSTEMATIC PURGE OF THE STEAM

CIRCUIT:

Each time before you make frothy milk, you

must purge the steam circuit:  

- Place an empty container under the steam

nozzle (k).

- Turn the Steam function selector switch (i) to

the position 

(i2) 

(fig. 12)

. The Steam light

(i4) comes on.

- Turn the Steam function selector switch (i) to

the position 

(i3) 

(fig. 13)

in order to purge

the circuit.

- When all the water inside the circuit has been

emitted, turn the Steam function selector

switch (i) back to the to the 

position (i2).

Warning! Do not remove the Filter holder

when the Coffee function selector switch (h)

is in the 

position (h2), and the coffee is

flowing.

IFU ROWENTA Opio EE 0828114:0828114  28/04/09  16:57  Page 13