Rowenta OPIO ES3200: GB

14

GB

(fig. 12)

(i2)

.

- Remove your container.

- Your device is ready to froth milk.

FROTHING MILK:

- Place the nozzle in the container of very fresh

cold milk (100 ml) without touching the

bottom and turn the steam function selector

switch (i) to the “ 

” position (i3) 

(fig. 13)

.

Keep the nozzle in this position for 15

seconds.

- Progressively lower and tilt your container so

that the steam nozzle comes right to the

surface of the milk.

- Once the desired quantity of froth has been

obtained, turn the Steam function selector

switch (i) back to the “O” position 

(fig. 15)

.

The appliance automatically cools down

(pump noise). At the end of this operation, the

Coffee indicator lamp (h3) comes on. Hot

water flows into the drip tray (m).

- Your appliance is ready to make an espresso

and finalise your cappuccino.

After the steam has stopped, quickly and

carefully clean the steam nozzle with a damp

sponge (so that the residue does not stick).

Place a container of water under the steam

nozzle and repeat the milk frothing process in

order to clean the nozzle out properly.

To unblock the hole in the steam nozzle outlet,

you may use a needle.

7. CLEANING AND  MAINTENANCE

OF THE APPLIANCE:

Make sure the coffee machine is unplugged

and completely cooled down before you begin

to clean it.

The removable parts can be cleaned using a

cloth and gentle washing-up liquid. water.

Do not immerse the coffee machine in water or

any other liquid.

OF THE FILTER HOLDER HOUSING:

Using a damp cloth, regularly clean the filter

holder housing in order to remove any coffee

residue which may be stuck there.

To prolong the life of the percolation head

gasket seal, do not put the filter holder back

into place if the coffee machine is not to be

used for a long time.

OF THE DRIP TRAY:

The drip tray must be emptied after each time

the appliance is used. 

If multiple espressos are prepared one after

another, it should be emptied from time to time 

(every 6 cups of espressos approximately)

(fig.17)

.

The presence of water is normal and is not the

sign of a leak. If necessary, clean the drip tray

(m) and its grid (l) with water and a little gentle

washing-up liquid, rinse and dry.

Make sure the drip tray is put back into place

properly 

(fig. 18)

.

8. DESCALING

The warranty does not cover appliances which

become faulty because the descaling

operations have not been carried out

periodically.

The coffee machine must be descaled regularly

as follows:

- Fill the tank with a mixture composed of three

parts water for one part white vinegar or a

mixture of ½ litre of water and a packet of

descaler (both white vinegar and descaler can

be purchased from hardware stores).

Place a container under the filter holder.

Turn the appliance on 

(fig 4).

- Allow around one third of the liquid to flow

from the tank by turning the Coffee function

selector (h) to the 

position (h2).

- Stop the appliance by pressing the On / Off

switch 

(fig. 4)

, leaving the switch (h) on the

position (h2).

- Wait for 10 to 15 minutes to let the descaler

work.

- Then turn the appliance back on by pressing

the On/Off switch again and let the rest of the

water run from the tank.

- Finally, carry out 2 machine rinse cycles with

a full tank of water in order to flush the

descaler out.

IMPORTANT! 

Caution! The steam nozzle is still hot! Careful

you don't burn yourself!

Caution! Do not put any of these parts into the

dishwasher.

IFU ROWENTA Opio EE 0828114:0828114  28/04/09  16:57  Page 14