Husqvarna 236: ASSEMBLY

H1153278-30,236R.fm Page 65 Friday, December 4, 2009 1:21 PM

ASSEMBLY

• Fit the protective sleeve as shown in the diagram.

Fitting the main body

Connect the engine (A) to the tube (B) with four screws

(C).

Connecting throttle cable and

stop switch wires

Assembling the handlebar and

throttle

1 Remove the air filter cover.

2 Insert the throttle cable (A) through the carburettor

bracket (B), then screw the cable adjuster sleeve (C)

• Fit the handlebar in the handlebar clamp on the shaft

into the carburettor bracket fully.

using four screws.

3 Position the slotted fitting (D) on the carburettor so the

recessed hole (E) for the cable lug (F) is away from the

cable adjuster sleeve.

4 Rotate the carburettor throttle cam and slip the throttle

cable through the slot in the slotted fitting, making

sure the cable lug drops into the recessed hole.

5 Operate the throttle trigger a few times to make sure

that it works correctly.

English – 65