Gigabyte 8VT800-RZ: Set Supervisor/User Password

Set Supervisor/User Password: Gigabyte 8VT800-RZ

English

Set Supervisor/User Password

CMOS Setup Utility-Copyright (C) 1984-2004 Award Software

} Standard CMOS Features

Load Fail-Safe Defaults

} Advanced BIOS Features

Load Optimized Defaults

} Integrated Peripherals

Set Supervisor Password

} Power Management Setup

Set User Password

} PnP/PCI Configurations

Enter Password:

Save & Exit Setup

} PC Health Status

Exit Without Saving

} Frequency/Voltage Control

ESC: Quit higf: Select Item

F8: Q-Flash F10: Save & Exit Setup

Change/Set/Disable Password

When you select this function, the following message will appear at the center of the screen to assist you

in creating a password.

Type the password, up to eight characters, and press <Enter>. You will be asked to confirm the password.

Type the password again and press <Enter>. You may also press <Esc> to abort the selection and not

enter a password.

To disable password, just press <Enter> when you are prompted to enter password. A message

"PASSWORD DISABLED" will appear to confirm the password being disabled. Once the password is

disabled, the system will boot and you can enter Setup freely.

The BIOS Setup program allows you to specify two separate passwords:

SUPERVISOR PASSWORD and a USER PASSWORD. When disabled, anyone may access all BIOS

Setup program function. When enabled, the Supervisor password is required for entering the BIOS

Setup program and having full configuration fields, the User password is required to access only basic

items.

If you select "System" at "Password Check" in Advance BIOS Features Menu, you will be prompted

for the password every time the system is rebooted or any time you try to enter Setup Menu.

If you select "Setup" at "Password Check" in Advance BIOS Features Menu, you will be prompted only

when you try to enter Setup.

- 35 - BIOS Setup