Acme WW01: Battery & adapter installation Setting up the wireless thermometer DCF77* radio-controlled clock

GB

Battery & adapter installation

Home Receiver Unit:

Main Power Source: Plug in the 6.0V adapter into the adapter socket at the back for basic operation

and continuous backlight.

Backup Power: Open the battery door, install 3 AAA backup batteries according to the polarity

indicated, and close the battery cover.

Remote Sensor:

Loosen the screws on the battery door with a small screwdriver, insert 2 AAA batteries according

to the polarity indicated. Set Channel 1 for the remote sensor. Replace the cover and tighten the

screws.

Setting up the wireless thermometer

• For the initial installation, always turn on the home unit and then the remote sensor.

• Press and hold [SNOOZE/CHANNEL/LIGHT] button on main unit until a beep sounds to search

for remote sensor. Outdoor temperature readings will ash indicating it is in the searching mode

• Press the [Tx] button on the back of remote sensor to transmit RF signal (Need to open sensors

back cover to nd the [Tx] button).

• When RF connection is established, the respective temperature of the selected channel will appear

on the main unit.

DCF77* radio-controlled clock

• The unit will start synchronizing the clock after battery/adapter installation or reset. In normal

mode, press [

/UP] until icon appears to enforce searching of radio-controlled clock signal. If

the icon disappears afterwards, radio time signal is not available at the moment. Try other locations

3