Beko WMD 25080 R: Warning
Warning: Beko WMD 25080 R
2
Warning
• This product is designed for home use.
quality and untting cleaning material is used the stains
will be xed. Before washing your laundry with stain
• Your washing machine is adjusted to 230V.
keep your attention on cleaning the laundry as explained
• If the fuse in your house is less than 16A than have a
in following pages.
certied electrician deploy an 16A fuse.
• In case of transformer or non-transformer use, ground-
• This is period of keeping spare parts for your machine
ing installation must be performed with a licensed
to operate. Because of quality control procedures there
electrician. Any use before grounding is not our respon-
might be little amount of water in your machine. This
sibility.
does not have any damage to your machine.
• Never place your machine over a carpet covered oor.
Otherwise electrical parts of your machine may over-
• Your machine is programmed for starting operation
heat. This may cause malfunction of your machine.
again when electricity is off and on afterwards. You can
not press On / Off button to cancel program. Machine
• Make sure hot and cold taps are connected correctly.
will go on program when electricity is on. To CANCEL
Otherwise your laundry may come out hot and torn .
the program press >Start/Pause/Cancel< button for
• Please call certied service for a failure of electric plug /
three seconds. (See. Cancelling a program)
cable.
If “Door” led on program progress display is blinking
• Be careful about your water hoses are not old. Do not
program selection knob is middle position. In this case
use old / torn water hoses. This may cause stain in your
turn the knob and adjust it again. If the warning contin-
laundry .
ues call authorized service.
• At rst use, washing must be performed at Cotton 90°C
• After your machine starts operation, if Start/Pause/
program without loading with laundry for getting your
Cancel key starts blinking than door is not locked. Open
machine ready for washing.
and close the door again begin washing program again.
• Performance of your washing machine depends on the
• If the “washing” led on the program progress display
quality of water and hygiene compound used. If low
is blinking either there is no water or tap is off. Check
7
your taps. Turn your machine off and on. If the problem
persists unplug your machine, turn off tap water and call
authorized service.
• If program is started and program selection can not be
performed your machine might be in protection mode
due to infrastructure problem (voltage, water pressure,
etc.) Press and hold the > Start/Pause/Cancel < button
for 3 seconds in order to switch machine to factory set-
tings.
• Most of the warnings resulting in calling an authorized
service are due to infrastructure problems. For this rea-
son applying to an Authorized Service is recommended.
8
Оглавление
- Technical Features of Your Washing Machine
- Your Washing Machine
- Warning
- Preparation
- Control Panel
- Auxiliary Functions
- Program Selection and Starting Machine
- Care and maintanence
- Installation
- Helpful tips on stain removal
- Before calling service
- Содержание
- Технические особенности Вашей стиральной машины
- Ваша Стиральная машина
- Предостережения по безопасности работы с машиной
- Подготовка к стирке
- Пульт управления
- Вспомогательные Функции
- Выбор программы и запуск машины
- Таблица выбора программ
- Уход за машиной и техническое обслуживание
- Установка