Beko CWB 9610 X: инструкция

GB

COOKER HOOD - User instructions

CZ

ODSAVAČ PAR – uživatelská příručka

DK

EMHÆTTE - Brugervejledning

FIN

LIESITUULETIN – Käyttöohje

GR

ΑΠΟΡΡΟΦΗΤΗΡΑΣ ΣΕ ΕΚΔΟΣΗ ΑΠΟΡΡΟΦΗΣΗΣ – Εγχειρίδιο χρήσης

H

ELSZÍVÓ KÜRTŐ – Használati utasítás

N

AVTREKKSKAPPE – Bruksanvisning

PL

OKAP ZASYSAJĄCY - instrukcja obsługi

R

HOTĂ ASPIRANTĂ – Manual de utilizare

RUS

ВЫТЯЖНОЙ КОЛПАК - Руководство пользователя

S

SPISKÅPA – Bruksanvisning

SLO

KUHINJSKA NAPA – Navodila za uporabo

HR

ISISNA NAPA – Upute za uporabu Pažljivo

LV

TVAIKU NOSŪCĒJS – Lietošanas instrukcija

LT

DŪMTRAUKIS – vartotojo instrukcijos

EST

TÕMBEKAPP - Kasutusjuhend

UA

ВИТЯЖКА - Інструкції з експлуатації

BG

КУХНЕНСКИ АСПИРАТОР – Инструкция за употреба

SK

ODSÁVAČ PÁR - Návod na použitie

SB

ASPIRATOR - Uputstvo za upotrebu

MK

АСПИРАТОР - Упатство за употреба

AR

A

B

max 90 cm

Fig.1

20

A

B

265

A

Fig.2 Fig.3

D

C

A

B

A

B

Fig.4

- 3 -

12

C

A

B

Fig.5

Fig.6

Fig.7

Fig.8

B

C

D

E

A

Fig.9

- 4 -

environment or to public health.

GB

ENGLISH

The

symbol on the product or on the accompanying

paperwork indicates that the appliance should not be treated

GENERAL

as domestic waste, but should be delivered to a suitable

electric and electronic appliance recycling collection point.

Carefully read the following important information regarding

Follow local guidelines when disposing of waste. For more

installation safety and maintenance. Keep this information

information on the treatment, re-use and recycling of this

booklet accessible for further consultations. The appliance

product, please contact your local authority, domestic waste

has been designed for use in the ducting version (air exhaust

collection service or the shop where the appliance was

to the outside – Fig.1B), filtering version (air circulation on

purchased.

the inside – Fig.1A) .

INSTALLATION INSTRUCTIONS

SAFETY PRECAUTION

Assembly and electrical connections must be carried out by

1. Take care when the cooker hood is operating simultaneously

specialised personnel.

with an open fireplace or burner that depend on the air in the

environment and are supplied by other than electrical energy,

• Electric Connection

as the cooker hood removes the air from the environment

The appliance has been manufactured as a class II, therefore

which a burner or fireplace need for combustion. The negative

no earth cable is necessary.

pressure in the environment must not exceed 4Pa (4x10-5 bar).

The connection to the mains is carried out as follows:

Provide adequate ventilation in the environment for a safe

BROWN = L line

operation of the cooker hood.Follow the local laws applicable

BLUE = N neutral

for external air evacuation.

If not provided, connect a plug for the electrical load

indicated on the description label. Where a plug is provided,

Before connecting the model to the electricity network:

the cooker hood must be installed in order that the plug is

- control the data plate (positioned inside the appliance)

easily accessible.

to ascertain that the voltage and power correspond to the

An omnipolar switch with a minimum opening of 3mm

network and the socket is suitable. If in doubt ask a qualified

between contacts, in line with the electrical load and local

electrician.

standards, must be placed between the appliance and the

- If the power supply cable is damaged, it must be replaced

network in the case of direct connection to the electrical

with another cable or a special assembly, which may be

network.

obtained direct from the manufacturer or from the Technical

Assistance Centre.

• The minimum distance between the support surfaces of

- This device must be connected to the supply network

the cooking pots on the cooker top and the lowest part of

through eiter a plug fused 3A or hardwired to a 2 fase spur

the cooker hood must be at least 65 cm. If a connection

protected by 3A fuse.

tube composed of two parts is used, the upper part must be

placed outside the lower part. Do not connect the cooker

2. Warning !

hood exhaust to the same conductor used to circulate hot air

In certain circumstances electrical appliances may be a

or for evacuating fumes from other appliances generated by

danger hazard.

other than an electrical source. Before proceeding with the

A) Do not check the status of the filters while the cooker

assembly operations, remove the anti-grease filter(s) (Fig.7)

hood is operating

so that the unit is easier to handle. In the case of assembly

B) Do not touch bulbs or adjacent areas, during or straight

of the appliance in the suction version prepare the hole for

after prolonged use of the lighting installation.

evacuation of the air.

C) Flambè cooking is prohibited underneath the cooker

hood

• We recommend the use of an air exhaust pipe with a

D) Avoid free flame, as it is damaging for the filters and

diameter of 150. If a pipe with a smaller diameter is used, the

a fire hazard

efficiency of the product may be reduced and its operation

E) Constantly check food frying to avoid that the

may become noisier

overheated oil may become a fire hazard

F) Disconnect the electrical plug prior to any

Please note:

maintenance.

If your version of the appliance has decorative glass before

G) This appliance is not intended for use by young children

installing the hood, carry out the following steps as shown

or infirm persons without supervision

in figure 4:

H) Young children should be supervised to ensure they do

1 - Remove both the cooker hood body B and the glass

not play with the appliance

panel A from the packaging and place them horizontally on

I) There shall be adequate ventilation of the room when

a secure surface.

the rangehood is used at the same time as appliances

2 - Take the glass panel A and position it above the cooker

burning gas or other fuels

hood body B.

L) There is a risk of fire if cleaning is not carried out in

3 - Fix the glass panel securely to the cooker hood body using

accordance with the instructions

the 4 sleeves C and 4 screws D as indicated.

This appliance conforms to the European Directive EC/2002/96,

• Fixing to the wall

Waste Electrical and Electronic Equipment (WEEE). By making

Drill the holes A respecting the distances indicated (Fig.2). Fix

sure that this appliance is disposed of in a suitable manner,

the appliance to the wall and align it in horizontal position

the user is helping to prevent potential damage to the

to the wall units. When the appliance has been adjusted,

- 5 -