Yamaha NS-SW310: Connecting to the INPUT1/OUTPUT Plug in the subwoofer to the AC outlet terminals of the subwoofer
Connecting to the INPUT1/OUTPUT Plug in the subwoofer to the AC outlet terminals of the subwoofer: Yamaha NS-SW310
Table of contents
- CAUTION: Read this before operating your unit
- • VOLTAGE SELECTOR SPECIAL INSTRUCTIONS FOR U.K. MODEL
- CONTENTS FEATURES
- SUPPLIED ACCESSORIES ATTACHING THE NON- SKID PADS
- PLACEMENT
- CONTROLS AND THEIR FUNCTIONS
- CONTROLS AND THEIR FUNCTIONS
- CONNECTIONS Connecting to line output (pin jack) terminals of the amplifier ■ Using one subwoofer
- ■ Using two subwoofers ■ Connecting to the LFE (INPUT3) terminal(s)
- Connecting to speaker output terminals of the amplifier ■ Using one subwoofer (with speaker cables) ■ Using two subwoofers (with speaker cables)
- ■ Using one subwoofer (with speaker cables) ■ Using two subwoofers (with speaker cables)
- Connecting to the INPUT1/OUTPUT Plug in the subwoofer to the AC outlet terminals of the subwoofer
- AUTOMATIC POWER-SWITCHING FUNCTION Changing the AUTO STANDBY setting
- ADJUSTING THE SUBWOOFER BEFORE USE
- Frequency characteristics
- ADVANCED YAMAHA ACTIVE SERVO TECHNOLOGY II
- TROUBLESHOOTING Problem Cause What to Do
- SPECIFICATIONS Limited Guarantee for European Economic Area (EEA) and Switzerland
CONNECTIONS
Connecting to the INPUT1/OUTPUT
Plug in the subwoofer to the AC outlet
terminals of the subwoofer
After all connections are completed, plug the subwoofer
and other audio/video components into AC outlets.
For connection, keep the speaker cables as short as
possible. Do not bundle or roll the excess cabling. If the
connections are faulty, no sound will be heard from the
subwoofer or the speakers, or both. Make sure that the +
and – polarity markings of the speaker cables are observed
and connected correctly. If these cables are reversed, the
sound will be unnatural and lack bass.
Caution
Do not let the bare speaker wires touch each other, because
this could damage the subwoofer or the amplifier, or both of
them.
■ Before connecting
Remove 10 mm (3/8”) of insulation from the ends of the
speaker cables.
To AC outlet
10 mm
(3/8 ”)
Good No Good
■ How to connect
1 Loosen the terminal’s knob, as shown in the figure.
2 Insert the bare wire.
3 Release your finger from the tab to allow it to lock
securely on the cable's wire end.
4 Test the firmness of the connection by pulling lightly
on the cable at the terminal.
Red: positive (+)
Black: negative (
–)
+
1
2
–
10 En
