Nikon SD-9: Notes on handling batteries
Notes on handling batteries: Nikon SD-9
Table of contents
- Notes on handling batteries
- For your safety WARNINGS for Battery pack CAUTIONS for Battery pack
- WARNINGS for Batteries Always follow the warnings and instructions printed on the batteries10. to
- Remove dead batteries from your equipment immediately,18. as they could
- Preparation Compatible Speedlight ■ Nomenclature ■
- En
- How to use the SD-9 Hooking the SD-9 up to the SB-900 ■
- En
- Specifications Major specifications in combination with the SB-900 ■
Notes on handling batteries
When replacing batteries, replace all four batteries of each set at the same time. •
Do not mix battery types or brands or use old with new batteries.
When installing batteries, turn off the power of the Speedlight and never reverse •
the polarity of the batteries.
If the battery terminals become soiled, remove dirt and smudges before use, as •
En
this may cause contact failure.
Battery power tends to weaken as the temperature drops. It also gradually •
decreases when batteries are not used for a long time and recovers after a short
break following intensive use. Be sure to check battery power and replace the
batteries with fresh ones if you notice any delays in the recycling time.
Do not store batteries in locations subject to high temperatures and high humidity. •
Because flash photography consumes a large amount of battery power, batteries •
may not operate fully before reaching the end of their stated lifespan or number
of charges as specified by the battery manufacturer.
11
