Beko WMD 25100 R: Warning

2

Warning

• This product is designed for home use.

quality and untting cleaning material is used the stains

will be xed. Before washing your laundry with stain

• Your washing machine is adjusted to 230V.

keep your attention on cleaning the laundry as explained

• If the fuse in your house is less than 16A than have a

in following pages.

certied electrician deploy an 16A fuse.

• In case of transformer or non-transformer use, ground-

• This is period of keeping spare parts for your machine

ing installation must be performed with a licensed

to operate. Because of quality control procedures there

electrician. Any use before grounding is not our respon-

might be little amount of water in your machine. This

sibility.

does not have any damage to your machine.

• Never place your machine over a carpet covered oor.

Otherwise electrical parts of your machine may over-

• Your machine is programmed for starting operation

heat. This may cause malfunction of your machine.

again when electricity is off and on afterwards. You can

not press On / Off button to cancel program. Machine

• Make sure hot and cold taps are connected correctly.

will go on program when electricity is on. To CANCEL

Otherwise your laundry may come out hot and torn .

the program press >Start/Pause/Cancel< button for

• Please call certied service for a failure of electric plug /

three seconds. (See. Cancelling a program)

cable.

If “Door” led on program progress display is blinking

• Be careful about your water hoses are not old. Do not

program selection knob is middle position. In this case

use old / torn water hoses. This may cause stain in your

turn the knob and adjust it again. If the warning contin-

laundry .

ues call authorized service.

• At rst use, washing must be performed at Cotton 90°C

• After your machine starts operation, if Start/Pause/

program without loading with laundry for getting your

Cancel key starts blinking than door is not locked. Open

machine ready for washing.

and close the door again begin washing program again.

• Performance of your washing machine depends on the

• If the “washing” led on the program progress display

quality of water and hygiene compound used. If low

is blinking either there is no water or tap is off. Check

7

your taps. Turn your machine off and on. If the problem

persists unplug your machine, turn off tap water and call

authorized service.

• If program is started and program selection can not be

performed your machine might be in protection mode

due to infrastructure problem (voltage, water pressure,

etc.) Press and hold the > Start/Pause/Cancel < button

for 3 seconds in order to switch machine to factory set-

tings.

• Most of the warnings resulting in calling an authorized

service are due to infrastructure problems. For this rea-

son applying to an Authorized Service is recommended.

8