Beko WKD 25100 T: Warning

2

Warning

• Thisproductisdesignedforhomeuse.

quality and unfitting cleaning material is used the stains

willbefixed.Beforewashingyourlaundrywithstain

• Yourwashingmachineisadjustedto230V.

keep your attention on cleaning the laundry as explained

• Ifthefuseinyourhouseislessthan16Athanhavea

in following pages.

certified electrician deploy an 16A fuse.

• Incaseoftransformerornon-transformeruse,ground-

• Thisisperiodofkeepingsparepartsforyourmachine

ing installation must be performed with a licensed

tooperate.Becauseofqualitycontrolproceduresthere

electrician. Any use before grounding is not our respon-

might be little amount of water in your machine. This

sibility.

does not have any damage to your machine.

• Neverplaceyourmachineoveracarpetcoveredfloor.

Otherwise electrical parts of your machine may over-

•Yourmachineisprogrammedforstartingoperation

heat. This may cause malfunction of your machine.

againwhenelectricityisoffandonafterwards.Youcan

not press On / Off button to cancel program. Machine

• Makesurehotandcoldtapsareconnectedcorrectly.

will go on program when electricity is on. To CANCEL

Otherwise your laundry may come out hot and torn .

the program press >Start/Pause/Cancel< button for

• Pleasecallcertifiedserviceforafailureofelectricplug/

three seconds. (See. Cancelling a program)

cable.

If “Door” led on program progress display is blinking

• Becarefulaboutyourwaterhosesarenotold.Donot

program selection knob is middle position. In this case

use old / torn water hoses. This may cause stain in your

turntheknobandadjustitagain.Ifthewarningcontin-

laundry .

ues call authorized service.

• Atfirstuse,washingmustbeperformedatCotton90°C

• Afteryourmachinestartsoperation,ifStart/Pause/

program without loading with laundry for getting your

Cancel key starts blinking than door is not locked. Open

machine ready for washing.

and close the door again begin washing program again.

• Performanceofyourwashingmachinedependsonthe

• Ifthe“washing”ledontheprogramprogressdisplay

quality of water and hygiene compound used. If low

is blinking either there is no water or tap is off. Check

7

your taps. Turn your machine off and on. If the problem

persists unplug your machine, turn off tap water and call

authorized service.

• Ifprogramisstartedandprogramselectioncannotbe

performed your machine might be in protection mode

due to infrastructure problem (voltage, water pressure,

etc.) Press and hold the > Start/Pause/Cancel < button

for 3 seconds in order to switch machine to factory set-

tings.

• Mostofthewarningsresultingincallinganauthorized

service are due to infrastructure problems. For this rea-

son applying to an Authorized Service is recommended.

8