Beko WKD 24500 T: Warning

2

Warning

• This product is designed for home use.

low quality and unfitting cleaning material is used the

stains will be fixed. Before washing your laundry with

• Your washing machine is adjusted to 230V.

stain keep your attention on cleaning the laundry as

• If the fuse in your house is less than 16A than have a

explained in following pages.

certified electrician deploy an 16A fuse.

• In case of transformer or non-transformer use, ground

-

• This is period of keeping spare parts for your machine

ing installation must be performed with a licensed

to operate. Because of quality control procedures

electrician. Any use before grounding is not our re-

there might be little amount of water in your machine.

sponsibility.

This does not have any damage to your machine.

• Never place your machine over a carpet covered floor.

Otherwise electrical parts of your machine may over-

• Your machine is programmed for starting operation

heat. This may cause malfunction of your machine.

again when electricity is off and on afterwards. You

can not press On / Off button to cancel program.

• Make sure hot and cold taps are connected correctly.

Machine will go on program when electricity is on. To

Otherwise your laundry may come out hot and torn .

CANCEL the program press >Start/Pause/Cancel<

• Please call certified service for a failure of electric plug

button for three seconds. (See. Cancelling a program)

/ cable.

If “Door” led on program progress display is blinking

• Be careful about your water hoses are not old. Do not

program selection knob is middle position. In this case

use old / torn water hoses. This may cause stain in

turn the knob and adjust it again. If the warning contin-

your laundry .

ues call authorized service.

• At first use, washing must be performed at Cotton

• After your machine starts operation, if Start/Pause/

90°C program without loading with laundry for getting

Cancel key starts blinking than door is not locked.

your machine ready for washing.

Open and close the door again begin washing pro-

• Performance of your washing machine depends on

gram again.

the quality of water and hygiene compound used. If

• If the “washing” led on the program progress display

7

is blinking either there is no water or tap is off. Check

your taps. Turn your machine off and on. If the prob-

lem persists unplug your machine, turn off tap water

and call authorized service.

• If program is started and program selection can not be

performed your machine might be in protection mode

due to infrastructure problem (voltage, water pressure,

etc.) Press and hold the > Start/Pause/Cancel < but-

ton for 3 seconds in order to switch machine to factory

settings.

• Most of the warnings resulting in calling an authorized

service are due to infrastructure problems. For this

reason applying to an Authorized Service is recom-

mended.

8