Главная > Инструкция к Стиральной Машине Beko WKD 24500 T > Installation

Beko WKD 24500 T: Installation

Installation: Beko WKD 24500 T

Installation

6

If your system is not ready, let a certified plumber make it

2. Leveling the feet

ready.

In order to operate your machine without noise and

vibration it must be properly on balance. Four feet of your

1. Removing the transportation safety bolts

machine can be adjusted. First loosen the plastic counter

bolt. Tighten the counter bolt after adjusting the feet for

Before the washing machine is operated, the transit bars

leveling your machine.

must be removed! In order to do this:

1. Loosen “C” bolts by rotating them counter clockwise

with a suitable spanner

3. Water Connections

2. Remove transportation safety bolts by turning.

3. Place “P” plastic covers onto the openings of transpor-

a) Water Inlet Hose

tation locks by rotating in direction of arrow and pushing.

Your machine is connected to water supply by special

hoses supplied by the machine. Red hose or hose

Attention please! Keep the transit bars for using when

written red on it is hot water inlet, blue hose or hose

machine is to be transported again. Always transport your

written blue on it is cold water inlet.

machine with transportation locks.

There are plastic seals (4 for double water inlet mod-

els, 2 for single water inlet models) on hose or plastic

bag for eliminating any leakage in connections points.

These seals must be used on each side of the con-

20

nection. Seals on machine side must be connected

filter cannal.

Do not connect single inlet machine to hot water. If

machine is connected with Y part to a double inlet

After connecting the hose, check all connections for

and over 40˚C for single inlet machines, machine may

leaks In order to eliminate any risk due to water leak-

switch to protection mode.

age keep the taps off when machine is not used.

b) Water drain hose

Water drain hose could be placed either at the side of the

bath tub, or directly to the drain. The hose should not be

bent. Water drain hose should be secured with the holder

so that it would not fall down on the ground.

The hose should be placed between 40 and 100 cm. from

the ground.

Your machine will operate efficiently if the water from

Water drain hose could be placed directly to the drain

tap is minimum 1 and maximum 10 bars. Practically 1

water inlet.

bar means 8 liters of water in one minute when tap is

fully on.

Connect hose to the machine. Tighten bolts with hand

power, do not use spanner.

Double inlet models can be used with blind cap as a

single inlet machine. Connect blind cap to hot water

inlet. Seal must be for stopping water leakage.

21

4. Electrical connection

Connect the power cord to the appropirate electrical

system which is being supported by the maximum voltage

and current rating indicated on the rating plate placed

inside the kick plate.

Look! Page 1, Steps before operating Fullautomatic

Washing Machine and safety precautions.

Make sure that you have grounded power outlet.

Attention! Before any operation of the machine check the

following.

• Did you close the front door?

• Is the tap open?

• Is water drain hose placed properly?

• Is power connected?

22

Оглавление

Топ 10 инструкций

Другие инструкции

Beko WKD 23560 R Beko WKD 23560 R Beko WKD 23580 T Beko WKD 23580 T Beko WKD 24560 R Beko WKD 24560 R Beko WKD 24580 T Beko WKD 24580 T Gorenje W98Z25I Gorenje W98Z25I Philips 37PFL5603S Philips 37PFL5603S