Beko WMB 81231 PTLMC: A

A: Beko WMB 81231 PTLMC

The hose should be attached to a

height of at least 40 cm, and 100 cm

at most.

In case the hose is elevated after

laying it on the floor level or close

to the ground (less than 40 cm

above the ground), water discharge

becomes more difficult and the

laundry may come out excessively

wet. Therefore, follow the heights

described in the figure.

1. Loosen the lock nuts on the feet by

hand.

To prevent flowing of dirty water back

2. Adjust the feet until the product

into the machine and to allow for easy

stands level and balanced.

discharge, do not immerse the hose

3. Tighten all lock nuts again by hand.

end into the dirty water or drive it in

the drain more than 15 cm. If it is too

long, cut it short.

The end of the hose should not be

bent, it should not be stepped on

and the hose must not be pinched

between the drain and the machine.

If the length of the hose is too short,

use it by adding an original extension

Do not use any tools to loosen the

A

hose. Length of the hose may not

lock nuts. Otherwise, they will get

be longer than 3.2 m. To avoid water

damaged.

leak failures, the connection between

Electrical connection

the extension hose and the drain

Connect the product to a grounded outlet

hose of the product must be fitted

protected by a fuse complying with the

well with an appropriate clamp as not

values in the "Technical specifications"

to come off and leak.

table. Our company shall not be liable

Adjusting the feet

for any damages that will arise when the

In order to ensure that the product

A

product is used without grounding in

operates more silent and vibration-

accordance with the local regulations.

free, it must stand level and balanced

Connection must comply with

on its feet. Balance the machine by

national regulations.

adjusting the feet. Otherwise, the

Power cable plug must be within easy

product may move from its place

reach after installation.

and cause crushing and vibration

The voltage and allowed fuse or

problems.

breaker protection are specified in

the “Technical specifications” section.

If the current value of the fuse or

breaker in the house is less than 16

10

EN