Mr Handsfree Blue Eagle II: INSTALLATIONINSTALLATION

GB – 3

INSTALLATION INSTALLATION

See Illustration III

1.  Insert the plug of the display cord (1) into the display cord jack (2) on the handsfree unit. Make sure the plug clicks into place. 

2.  Insert the handsfree unit into the cigarette lighter of your car. 

3.  Slide the adjuster (3) in the arrow direction to fasten the handsfree unit.

4.  Place the display unit at a location where you can watch the LCD easily. The microphone (4) should be pointed towards your 

mouth. For optimal performance, the microphone should be located at a distance of 40-50 cm from the driver’s mouth.

TURNING THE CARKIT ON/OFF TURNING THE CARKIT ON/OFF

When you turn on the ignition of your car, the Blue Eagle II is turned on automatically. 

 The blue LED flashes every 3 seconds and 

the display shows the “

VOL

” icon. 

 The unit is now in Standby mode and ready for use.

When you turn off the ignition of your car, the Blue Eagle II is turned off automatically.

PAIRING PAIRING

You are required to pair the Blue Eagle II with your mobile phone before using it. Do the following steps to pair the Blue Eagle II 

with your mobile phone:

Press and hold 

MFB

 in Standby mode (up to 10 seconds) until a prompt tone is heard and the red and blue LED’s flash alternately. 

 The Blue Eagle II is now ready for pairing, and a continuous line flashes on the display. 

 Initiate the pairing process on your 

Bluetooth

®

 mobile phone to pair with the Blue Eagle II (Please refer to the manual of your mobile phone). 

 You will be asked to 

enter the passkey. The default passkey is “0000”. 

 Enter the passkey and confirm. 

 When the pairing has been successful, the 

display shows “

VOL

” and the Blue Eagle II returns to Standby mode. 

Note:

If there is no device linked within 2 minutes after the Blue Eagle II enters pairing mode, the Blue Eagle II will return to 

Standby mode.

Your Blue Eagle II can store pairing information for up to two different Bluetooth

®

 devices. After switch on, the Blue Eagle II will au-

tomatically search the last mobile phone it was connected to. In case this phone is not available, the Blue Eagle II will automatically 

search for the previously paired phone for connection.

m_BlueEagleII_GB.indd   3

m_BlueEagleII_GB.indd   3

10.10.2006   14:44:06

10.10.2006   14:44:06