Imetec SENSUIJ SM5-200: EN DESCRIPTION OF THE APPLIANCE AND ACCESSORIES (fig.A)

EN DESCRIPTION OF THE APPLIANCE AND ACCESSORIES (fig.A): Imetec SENSUIJ SM5-200

EN

DESCRIPTION OF THE APPLIANCE AND ACCESSORIES (fig.A)

1-6. securing straps

2. Rotating massaging heads

3. Connectors

4. Mains power supply with connectors

5. Control

ASSEMBLY/PREPARATION

Unpack the product and remove the stops used for transport.

Check that it is integral and undamaged.

Upon commissioning, release the transport safety device of the massaging

mechanism. Loosen the screw on the rear of the chair back using the appropriate

tool.

43

ATTENTION!

The massager pillow will be irreparably damaged and it will no longer be usable unless

the transport safety screw is removed before using the product. This case is not covered

by warranty. Once removed, the screw must no longer be re-inserted.

The massager pillow is supplied with Velcro securing straps making it possible to adapt it to the

majority of chairs available on the market. Pass the two straps (1) (6) behind the chair back and

secure them to each other using the Velcro. If you prefer, simply rest the massager pillow on your chair

or armchair. Do not use it on wooden surfaces as it may be damaged.

ATTENTION!

The massager pillow is unsuitable for use in a car.

Connect the transformer to the massager pillow via the specific connectors (3) (4).

Connect the product to the domestic mains.

USE

Press the ON/OFF (5) key to switch-on the massager pillow.

Press the ON/OFF (5) key again to stop.

HEAT: heating function.

Press the HEAT (5) button to activate heat during the massage. The HEAT function activates only if the

massage is functioning.

Press it again to deactivate it.

Use a towel if wanting a more delicate massage.

AUTOMATIC SHUTDOWN

The massager pillow turns itself off automatically after 15 minutes. This function does not replace the

normal turning off of the product, which must be off when not in use.

When the product is switched off, the massage mechanism always returns to starting position. When

switched on again, the massage will start from this position.