Yamaha NS-SW210: PLACEMENT CONTROLS AND THEIR FUNCTIONS

PLACEMENT

CONTROLS AND THEIR

FUNCTIONS

A

Front Rear

B

Power indicator

Lights up Green when the POWER switch is turned

ON; turns off when the POWER switch is turned OFF.

INPUT (FROM AMPLIFIER) terminal

Used to connect the subwoofer with the subwoofer

terminal of the amplifier.

( : subwoofer, : front speaker)

(Refer to “CONNECTIONS” for details.)

VOLUME control

The subwoofer will have a good effect on your audio

Adjusts the volume level. Turn the control clockwise to

system.

increase the volume, and counterclockwise to decrease

the volume.

Using the subwoofer, it is recommended to place it on the

POWER switch

outside of either the right or the left front speaker. (See fig.

Press this switch to the ON position to turn on the

A

.) The placement shown in fig. is also possible,

B

power to the subwoofer. Press this switch again to set

however, if the subwoofer system is placed directly facing

it to the OFF position to turn off the power of the

the wall, the bass effect may suffer due to cancellation of

subwoofer.

direct and reflected sounds. To prevent this from

VOLTAGE SELECTOR switch

happening, place the subwoofer system at an angle, as in

(Asia and General models only)

fig. .

A

If the preset setting of the switch is incorrect, set the

switch to the proper voltage (110-120/220-240V) of

your area.

Note

Consult your dealer if you are unsure of the correct

There may be a case that you cannot obtain enough

setting.

super-bass sounds from the subwoofer when listening

in the center of the room. This is because “standing

WARNING

waves” have developed between two parallel walls and

Be sure to unplug the subwoofer before setting the

cancel the bass sounds.

VOLTAGE SELECTOR switch correctly.

In such a case, place the subwoofer at an oblique angle

to the wall. It also may be necessary to break up the

parallel surfaces by placing bookshelves, etc. along the

walls.

2 En