Yamaha AX-497: Connecting the power supply cord

10

CONNECTIONS

■

Connecting the AC power supply cord

Plug the power supply cord into the AC wall outlet after 

all other connections are complete. 

■

AC OUTLET(S) (SWITCHED)

U.K. and Australia models ..................................... 1 outlet

Korea model .............................................................. None

Other models ........................................................ 3 outlets

Use these outlets to connect the power cords from your 

other components to this unit. The power to the AC 

OUTLET(S) is controlled by POWER or STANDBY/ON 

on the front panel of this unit (or on the remote control). 

The outlet(s) supply power to any connected component 

whenever the power of this unit is turned on. For 

information on the maximum power (total power 

consumption of components), see “SPECIFICATIONS” 

on page 18.

■

VOLTAGE SELECTOR

(Asia and General models only)

The VOLTAGE SELECTOR on the rear panel of this unit 

must be set for your local main voltage BEFORE plugging 

the power supply cord into the AC wall outlet. 

Voltages are as follows:

Asia model.......................... AC 220/230–240 V, 50/60 Hz

General model ...... AC 110/120/220/230–240 V, 50/60 Hz

Connecting the power supply cord

AC OUTLETS

VOLTAGE SELECTOR

IMPEDANCE SELECTOR

SWITCHED

100W MAX. TOTAL

A OR B: 4

Ω

MIN / SPEAKER

A+B: 8

Ω

MIN / SPEAKER

A OR B:   6

Ω

MIN / SPEAKER

A+B: 12

Ω

MIN / SPEAKER

(General model)

To an AC wall outlet

AC power supply cord