Nikon Другие-устройства-дистанционного: Parts of the MC-36 (3/3) Connecting the MC-36 The Illuminator/Lock Button

En

7

Parts of the MC-36 (3/3) Connecting the MC-36

The “TIMER ACTIVE,” “SET,” and “RELEASE” Indicators

The Illuminator/Lock Button

1 Turn the camera off .

Press the illuminator/lock button () briefl y to

2 Check that the “TIMER ACTIVE” () and “RE

activate the control panel backlight. The back-

LEASE” () indicators are not displayed.

light will remain lit for about six seconds; press-

3 Remove the 10-pin terminal cover from the

ing the arrow button () while the backlight is

camera. Keeping the mark on the 10-pin

If this  ashes It means this; do this to turn it o

on extends the timer for another six seconds.

connector () aligned with the mark on the

Timer active (page 13); press TIM

To lock all controls except the shutter-re-

camera body, insert the connector as shown

TIMER ACTIVE

ER START/STOP button ().

lease () and illuminator/lock buttons, press

and then tighten the locking nut.

Settings can be modifi ed (page

the illuminator lock button until the lock icon

SET

8); press SET button ().

(

) is displayed in the control panel. To release

RELEASE

Manual release active (page 15);

the lock, press the illuminator/lock button until

(TIMER

release shutter-release button

the lock icon is no longer displayed.

ACTIVE not

(; if button is in HOLD position,

fl ashing)

release shutter-release lock).

Disconnecting the MC-36

After checking that the “TIMER ACTIVE” () and “RE

LEASE” () indicators are not displayed, turn the

camera off and disconnect the MC-36. Replace

the 10-pin terminal cover.