Gorenje DK 9315 X: Installation Maintenance Cleaning Electrical connection Grease filter Mounting Charcoal filter (filter version only) Operation
Installation Maintenance Cleaning Electrical connection Grease filter Mounting Charcoal filter (filter version only) Operation: Gorenje DK 9315 X
Table of contents
- EN - Instruction on mounting and use Caution Use Ducting version Filter version
- Installation Maintenance Cleaning Electrical connection Grease filter Mounting Charcoal filter (filter version only) Operation
- Replacing lamps

Installation
Maintenance
Fig. 3
ATTENTION! Before performing any maintenance operation,
The minimum distance between the supporting surface for the
isolate the hood from the electrical supply by switching off at
cooking equipment on the hob and the lowest part of the
the connector and removing the connector fuse.
range hood must be not less than 50cm from electric cookers
Or if the appliance has been connected through a plug and
and 70cm from gas or mixed cookers.
socket, then the plug must be removed from the socket.
If the instructions for installation for the gas hob specify a
greater distance, this must be adhered to.
Cleaning
The cooker hood should be cleaned regularly (at least with the
Electrical connection
same frequency with which you carry out maintenance of the
The mains power supply must correspond to the rating
fat filters) internally and externally. Clean using the cloth
indicated on the plate situated inside the hood. If provided with
dampened with neutral liquid detergent. Do not use abrasive
a plug connect the hood to a socket in compliance with current
products. DO NOT USE ALCOHOL!
regulations and positioned in an accessible area, after
WARNING: Failure to carry out the basic cleaning
installation. If it not fitted with a plug (direct mains connection)
recommendations of the cooker hood and replacement of the
or if the plug is not located in an accessible area, after
filters may cause fire risks.
installation, apply a double pole switch in accordance with
Therefore, we recommend oserving these instructions.
standards which assures the complete disconnection of the
The manufacturer declines all responsibility for any damage to
mains under conditions relating to over-current category III, in
the motor or any fire damage linked to inappropriate
accordance with installation instructions.
maintenance or failure to observe the above safety
Warning! Before re-connecting the hood circuit to the mains
recommendations.
supply and checking the efficient function, always check that
the mains cable is correctly assembled.
Grease filter
Traps cooking grease particles.
Warning! Power cable replacement must be undertaken by
The grease filter must be cleaned once a month using non
the authorised service assistance centre or similar qualified
aggressive detergents, either by hand or in the dishwasher,
person.
which must be set to a low temperature and a short cycle.
When washed in a dishwasher, the grease filter may discolour
Mounting
slightly, but this does not affect its filtering capacity.
Expansion wall plugs are provided to secure the hood to most
To remove the grease filter, pull the spring release handle.
types of walls/ceilings. However, a qualified technician must
Fig. 1
verify suitability of the materials in accordance with the type of
wall/ceiling. The wall/ceiling must be strong enough to take
Charcoal filter (filter version only)
the weight of the hood. Do not tile, grout or silicone this
Fig. 2
appliance to the wall. Surface mounting only.
It absorbs unpleasant odours caused by cooking.
The saturation of the activated charcoal occurs after more or
less prolonged use, depending on the type of cooking and the
Operation
regularity of cleaning of the grease filter.
The hood is fitted with a control panel with aspiration speed
In any case it is necessary to replace the cartridge at least
selection control and a light switch to control cooking area
every four mounths.
lights.
The carbon filter may NOT be washed or regenerated.
Use the high suction speed in cases of concentrated kitchen
Remove the grease filters.
vapours. It is recommended that the cooker hood suction is
Fit the charcoalfilters over the motor.
switched on for 5 minutes prior to cooking and to leave in
Align the pins R on the cowl with the slots S, then turn the
operation during cooking and for another 15 minutes
filter clockwise until it locks in place.
approximately after terminating cooking.
Reverse the above procedure to remove the charcoal filters.
Refit the grease filters.
a. ON/OFF light switch
b. Speed 1/OFF switch
c. 2-speed selection
d. 3-speed selection
11

