Vaddio HE120 Operating Instructions: Concerning the wireless remote control (optional accessory)

Concerning the wireless remote control (optional accessory)

This unit can be operated by remote control using a

wireless remote control (model number: AW-RM50G)

purchased separately.

Check out the following points before using the wireless

remote control.

Consult your dealer concerning the purchase of a

wireless remote control.

 Operate the wireless remote control from positions

less than 10 meters (32.8 ft) away from the unit.

 The wireless remote control may not work when it is

pointed from certain angles at the unit.

From a place where the wireless remote control signal

light-sensing area (hereafter, “light-sensing area”) can be

seen, point the signal transmission window of the wireless

remote control at the light-sensing area, and operate the

buttons.

It may prove to be more difficult to operate the unit when

the remote control is operated from behind the unit.

 If the unit is installed near fluorescent lights, plasma

monitors or other such products or if the unit is

exposed to sunlight, the effects of the light may make

it impossible for the unit to be operated using the

wireless remote control.

Be sure to follow the steps below for installation and use.

• Take steps to ensure that the light-sensing area will not

be exposed to the light from fluorescent lights, plasma

monitors or other such products or from the sun.

• Install the unit away from fluorescent lights, plasma

monitors and other such products.

 For about 10 minutes even after the batteries have

been removed from the wireless remote control,

the selection of the operation to be performed (the

[CAM1], [CAM2], [CAM3] or [CAM4] button which was

pressed last) will remain stored in the memory.

When a longer period of time elapses, however, the

selection is reset to the status established when the

[CAM1] button was pressed.

34