Yamaha NS-PA120: Installing the surround speakers Wall-mounting the speakers

Installing the speakers

English

Installing the surround speakers

(A) Bottom

Place the left and right surround speakers

behind your listening position, facing slightly

inward.

When placing them on a flat surface (hard

floor, etc), affix the supplied non-skid pads to

the corners of the bottom of the speaker as

shown left (Fig. A). The pads will prevent the

Non-skid pad

speaker from moving around.

When wall-mounting them, affix the supplied

non-skid pads to the lower corners of the back

of the speaker as shown left

(B) Back

(Fig. B). For details, see “Wall-mounting the

speakers”.

Non-skid

pad

Wall-mounting the speakers

You can mount the center and surround

Surround speaker

Wall/wall support

speakers on the wall as follows.

26 mm (1")

1 Install screws into a solid wall or wall

support as shown left. Use 3.5 to 4 mm

3 mm

(1/8") diameter self-tapping screws.

(1/8")

2 Hang each speaker by its keyhole slots

Minimum

onto the protruding screws.

20 mm (3/4")

Note

• Make sure the shaft of the screw is seated in

the narrow part of the keyhole slot.

Center speaker

Otherwise, the speaker may fall.

245 mm

(9-5/8")

Warnings

• Each speaker weighs 1.8 kg (4.0 lbs.). Do not mount the speakers on thin plywood or on a wall with a soft surface

material. Otherwise, the screws may pull out of the surface and the speakers may fall, possibly damaging the speakers

or causing personal injury.

• Do not affix the speakers to a wall using nails, adhesives, or unstable hardware. Long-term use and vibration may

cause the speakers to fall.

• To avoid accidents resulting from tripping over loose speaker cables, affix the cables to the wall.

• Mount the speakers in a wall location that will be unlikely to result in injury to an individual’s head.

• When using speaker brackets (commercially available) to mount the speakers on the wall or ceiling, we strongly

recommend using safety wire (may be supplied with the bracket) between the speaker and bracket to prevent the

speaker from falling.

• If you are not sure of a safe way to install these speakers, consult a professional installer or a building contractor.

4 En