Yamaha NS-SW210: PLACEMENT CONTROLS AND THEIR FUNCTIONS
PLACEMENT CONTROLS AND THEIR FUNCTIONS: Yamaha NS-SW210
PLACEMENT
CONTROLS AND THEIR
FUNCTIONS
A
Front Rear
B
Power indicator
Lights up Green when the POWER switch is turned
ON; turns off when the POWER switch is turned OFF.
INPUT (FROM AMPLIFIER) terminal
Used to connect the subwoofer with the subwoofer
terminal of the amplifier.
( : subwoofer, : front speaker)
(Refer to “CONNECTIONS” for details.)
VOLUME control
The subwoofer will have a good effect on your audio
Adjusts the volume level. Turn the control clockwise to
system.
increase the volume, and counterclockwise to decrease
the volume.
Using the subwoofer, it is recommended to place it on the
POWER switch
outside of either the right or the left front speaker. (See fig.
Press this switch to the ON position to turn on the
A
.) The placement shown in fig. is also possible,
B
power to the subwoofer. Press this switch again to set
however, if the subwoofer system is placed directly facing
it to the OFF position to turn off the power of the
the wall, the bass effect may suffer due to cancellation of
subwoofer.
direct and reflected sounds. To prevent this from
VOLTAGE SELECTOR switch
happening, place the subwoofer system at an angle, as in
(Asia and General models only)
fig. .
A
If the preset setting of the switch is incorrect, set the
switch to the proper voltage (110-120/220-240V) of
your area.
Note
Consult your dealer if you are unsure of the correct
There may be a case that you cannot obtain enough
setting.
super-bass sounds from the subwoofer when listening
in the center of the room. This is because “standing
WARNING
waves” have developed between two parallel walls and
Be sure to unplug the subwoofer before setting the
cancel the bass sounds.
VOLTAGE SELECTOR switch correctly.
In such a case, place the subwoofer at an oblique angle
to the wall. It also may be necessary to break up the
parallel surfaces by placing bookshelves, etc. along the
walls.
2 En
Оглавление
- CAUTION: Read this before operating your unit
- CONTENTS FEATURES
- PLACEMENT CONTROLS AND THEIR FUNCTIONS
- CONNECTIONS ADJUSTING THE SUBWOOFER BEFORE USE
- ADVANCED YAMAHA ACTIVE SERVO TECHNOLOGY II
- SPECIFICATIONS
- ATTENTION : lisez les consignes suivantes avant d’utiliser l’appareil
- TABLE DES MATIERES CARACTÉRISTIQUES
- DISPOSITION PRÉSENTATION DES COMMANDES ET DE
- BRANCHEMENTS RÉGLAGE DU CAISSON DE GRAVES AVANT UTILISATION
- TECHNOLOGIE ADVANCED YAMAHA ACTIVE SERVO TECHNOLOGY II
- CARACTÉRISTIQUES TECHNIQUES
- ACHTUNG: Lesen Sie diese Informationen, bevor Sie den Lautsprecher verwenden
- INHALTSVERZEICHNIS GERÄTEMERKMALE
- PLATZIERUNG DIE BEDIENTEILE UND IHRE FUNKTIONEN
- ANSCHLÜSSE EINSTELLUNG DES SUBWOOFERS VOR GEBRAUCH
- ADVANCED YAMAHA ACTIVE SERVO TECHNOLOGY II
- TECHNISCHE DATEN
- FÖRSIKTIGT: Läs följande innan du använder enheten
- INNEHÅLL EGENSKAPER
- PLACERING REGLAGE OCH DERAS FUNKTIONER
- ANSLUTNINGAR JUSTERING AV SUBWOOFERHÖGTALAR
- ADVANCED YAMAHA ACTIVE SERVO TECHNOLOGY II
- TEKNISKA DATA
- ATTENZIONE: leggere il presente documento prima di utilizzare il dispositivo
- INDICE CARATTERISTICHE
- POSIZIONAMENTO COMANDI E RELATIVE FUNZIONI
- CONNESSIONI REGOLAZIONE DEL SUBWOOFER PRIMA
- ADVANCED YAMAHA ACTIVE SERVO TECHNOLOGY II
- SPECIFICHE TECNICHE
- PRECAUCIÓN: lea esta información antes de utilizar la unidad
- CONTENIDO CARACTERÍSTICAS
- UBICACIÓN CONTROLES Y SUS FUNCIONES
- CONEXIONES AJUSTE DEL ALTAVOZ DE ULTRAGRAVES
- ADVANCED YAMAHA ACTIVE SERVO TECHNOLOGY II
- ESPECIFICACIONES
- LET OP: lees eerst deze aanwijzingen alvorens het apparaat in gebruik te nemen
- INHOUD KENMERKEN
- OPSTELLING BEDIENINGSELEMENTEN EN HUN FUNCTIES
- AANSLUITINGEN INSTELLING VAN DE SUBWOOFER VOOR
- ADVANCED YAMAHA ACTIVE SERVO TECHNOLOGY II
- SPECIFICATIES
- ПРЕДУПРЕЖДЕНИЕ: Внимательно прочитайте этот документ перед использованием аппарата
- СОДЕРЖАНИЕ СВОЙСТВА
- РАЗМЕЩЕНИЕ ОРГАНЫ УПРАВЛЕНИЯ И ИХ ФУНКЦИИ
- СОЕДИНЕНИЯ РЕГУЛИРОВКА
- ТЕХНОЛОГИЯ ADVANCED YAMAHA ACTIVE SERVO TECHNOLOGY II
- ТЕХНИЧЕСКИЕ ХАРАКТЕРИСТИКИ