Jotul I530FL: 4.0 Servicing

17

3.7 Assembly/installation

Installation to the chimney (Fig. 7) 

1.  Test-mount the insert first without making a hole in the 

chimney.  See Fig. 1 for distances to firewall. 

2.  The insert may be installed with a Ø200 mm flue pipe of 

approved thickness. 

3.  Place the insert into its final position. Secure the flue pipe in 

the insert’s smoke outlet using gasket rope.

NB: It is important that the joints are completely sealed. Air 

leakage may cause malfunction. 

3.8 Checking the functions (Fig. 8) 

Check the control handles once the insert is in place. These should 

move easily and work in a satisfactory manner. 

Air vent (A) 

Left position  =  closed

Right position  =  open

4.0 Servicing

Warning! Any unauthorised changes to the product are illegal! 

Only original spare parts may be used!

4.1 Replacing the burn plates (Fig. 9) 

1.  Lift up the log retainer (A) and then take it out. 

2.  Remove the side burn plates (B) by lifting them slightly and 

pulling out. If they are difficult to remove, use a screwdriver 

to draw them up. 

3.  Then lift the back burn plate out (C). 

4.  Check that the insulation is in place before putting the burn 

plates into place. 

5.  Begin with the back burn plate. Then put the side burn plates 

into place. Lift them slightly using the knobs at the bottom 

of the plates so that they are locked into place by the edges 

in the base of the insert.

4.2 Removing/assembling the door 

The door must be opened before it can be removed. 

1.   Tap out the hinge pins and pull out the door. 

2.   When assembling the door, any washers under the lowest 

hinge pins must be put into place. 

3.  Change gaskets at the same time. 

ENGLISH

4.3 Removing/assembling the front 

(Fig. 11) 

1.  Remove the door, lower cover and burn plates. (See separate 

section.) 

2.   Half unscrew the screws 

(A)

 in the lower front edge of the 

burn chamber and pull the washers out completely towards 

the screw head. 

3. Loosen 

the 

screws 

(B)

 in the upper front edge of the burn 

chamber. These screws have washers and nuts on the inside. 

Hold the front so that it does not fall forward when loosening 

the last screw. 

4.   Lift the front off. 

5.   Assemble the front by placing it on the two screws that are 

half-screwed in 

(A)

 in step 2. The screws fit into the slots in 

the front. 

6.   Push the frame into the upper edge. Lift it slightly so that it 

reaches the top. Secure the frame with M6 x 30 mm screws 

(B)

 and nuts with washers on the inside of the burn chamber. 

5.0 Optional extras

5.1 Panel 

Cat. no. 50013007

5.2. Glass 

Cat. no. 51012308

(The Glas, cat. no. 51012308, cannot be used in combination with 

the panel, cat. no. 50013007).

5.3 Ash lip 

Cat. no. 51012307

5.4 Internal ash solution

Cat. no. 51012053