Jotul F3: 4.0 Service

24

ENGLISH

4.0 Service

Warning!

 Any unauthorised change to the product is illegal! 

Only use original spare parts!

4.1 Replacing the Air Chamber 

Remove the door to avoid any damages to the glass or enamel.

Disconnect the top plate of Jøtul F 

3

. This is connected to the 

side plates with 2 collar head screws - one on each side. See 

fig. 3

. 

Remove these with the Allen key which are supplied with the 

stove.

In the case of side/rear connection, the following should 

be done:

1.  Unscrew the heat shield 

(fig. 4B)

. It will then be possible 

to use a screw driver to keep in place the screw which is 

situated there. 

2.  Unscrew the nuts under the air chamber at the back edge 

(towards the back wall), one on each side 

(fig. 8)

. 

3.  The air chamber is fastened at the front to the side burn 

plates with the screws 

(fig. 9)

. These are loosened and the 

air chamber can then be lifted out from above.

In the case of top connection, the following should be 

done:

•  Lift out the ash moulding (the log stopper). 

•  The air chamber is lifted out through the door opening with 

one hand, while at the same time flipping in and pulling out 

the one of the side burn plates. 

The air chamber may now be lowered diagonally and twisted 

out via the door opening.

Assembly of a new air chamber

Follow the same procedure in reverse order.

4.2 Changing the burn plates/inner 

base plate

Follow the same procedure as for: 

«4.1 Replacing the Air 

Chamber».

Defected parts can be removed and replaced once everything is 

loosened. First remove the side burn plates, then the back burn 

plate. Finally, the inner base plate is then removed. If the parts 

get somewhat stuck, use a large screwdriver or something similar 

to flip them loose. When assembling, the same procedure is 

followed in reverse order.

NB! Important notice!

Ensure that the insulation sheet behind the burn plates, together 

with all of the gaskets, are intact before assembly takes place. It 

may also be necessary to change some screws and nuts. 

5.0 Optional equipment

5.1 Firescreen - cat. no. 50012922 

(350166) 

If the stove is being used with the door open, always use a 

firescreen. It is affixed by two claws at its bottom edge and a 

spring clip which is pressed into the door opening at the top.

5.2 Floor plate

A decorative enamel floor plate is available for your Jøtul F 

3

. 

The dimensions of the plate are: 6

3

2 x 772 x 16,5 mm

5.3 Decorative ring - cat. no. 51012200 

(350466)

When the cover in the top plate is removed a small opening 

is created between the smoke outlet and the smoke pipe. The 

opening can be covered by a decorative ring. The ring can be 

delivered in the colours of the fire place.