Toshiba JournE F800-F801: Safety Instructions
Safety Instructions: Toshiba JournE F800-F801
Table of contents
- Safety Instructions
- Follow the instructions below to install and operate the unit. Step 1: Check the components
- Controls on the front Controls on the back
- Step 2: Install the adjustable foot stand.
- Step 3: Connect the AC power.
- Step 4: (Optional) Insert a memory card.
- Step 5: Turn on the unit. Step 6: Operate the unit.
- Using the Photo mode Using the Calendar mode
- Using the Music mode Using the Video mode
- Additional features (available on PA3702*-1ET2 only) Built-in battery
- Built-in tilt sensor Built-in light sensor
- Frequently asked questions
- TOSHIBA support Regulatory Information
- Working Environment Additional environments not related to EMC
- Following information is only valid for EU-member states Disposal of products Disposal of batteries and/or accumulators
GMH300056020.book Page 3 Tuesday, September 2, 2008 10:46 PM
Safety Instructions
Before operating this unit (Journe F800/F801),
please carefully read and follow the instructions
below.
n The operating temperature is between 0 and 40 degrees Celsius.
n Do not use or store this unit in the environments listed below:
n Direct sunlight
n A high-humidity area such as bathroom
n Dusty places
n Next to an air conditioner, electric heater or other heat sources
n In a closed car that is in direct sunlight
n Unstable locations
n If this unit becomes wet, wipe it with a dry cloth as soon as
possible.
n Salt or seawater may cause severe damage to this unit.
n Do not use solvents (such as alcohol) to clean this unit.
n If the screen is dirty, use a lens brush or soft cloth to clean the
screen.
n To prevent electric shock, do not attempt to disassemble or repair
this unit by yourself.
n Water may cause a fire or electric shock. Therefore, store this unit
in a dry place.
n Do not use this unit outdoors when it is raining or snowing.
n Do not use this unit in or near water.
n If a foreign substance or water gets in this unit, please turn the
power off immediately and disconnect the power adapter. Next,
remove the foreign substance or water, and then send it to your
nearest service center.
User’s Manual EN-3
