Rowenta INTENSIUM UPGRADE RO6663: 5 • Clean the HEPA filter (17)

EN

ATTENTION Leave the microfilter to

Leave them to dry for 6H (fig.31).

Put the parts of the filtration system (4) back

dry and make sure it is thoroughly dry

in place:

before putting it back in the appliance.

- replace the separation grid (4b) on the

separator (4a)

(fig.32)

Replace the microfilter and the black foam

- replace the separation compartment (4c) on

filter and close the cover.

the unit (4a + 4b)

(fig.33-34)

- then replace the entire separation system

5 • Clean the HEPA filter (17)

(4a+4b+4c) in the vacuum

(fig.35) and close

the lid.

IMPORTANT

If after cleaning the black

filter foam and microfilter, your vacuum

7 • Clean your vacuum cleaner

cleaner does not resume its previous

Wipe the body of the vacuum cleaner and

performances, clean the HEPA filter.

the accessories with a soft damp cloth, then

Otherwise, clean the HEPA filter once a

dry using a dry cloth.

year.

Wash the dust compartment with water, then

dry with a dry cloth.

Unlock the air outlet grid on the side of the

appliance by rotating it slightly to the left

IMPORTANT Do not use detergents or

(fig.22) and remove it by pulling it (fig.23).

any corrosive or abrasive products. The

Remove the HEPA filter from its housing

(fig.24). Clean the HEPA filter by knocking it

transparency of the dust compartment

gently over a dustbin

(fig.25). Put it back in

and/or the front and/or lid may change

its housing. Replace the air outlet grid and

over time. This does not affect

lock it by rotating it slightly clockwise.

performance.

IMPORTANT

If the HEPA filter is

damaged, replace it. The HEPA filter is

ATTENTION

Do not wash the vacuum

available in Authorised Service Centres.

lid under water. Clean it with a soft damp

cloth.

6 • Clean the separator (4)

Open the lid of the vacuum cleaner (fig.16-

17)

.

Press the separator button

(fig.26) and

remove the separation system

(fig.27).

Remove the separation compartment (4c) by

turning it slightly to the left

(fig.28) then

separate the two components

(fig.29).

Remove the separation grid (4b)

(fig.30).

Wash the components (4a +4 b +4 c) in clear

water.

10