Fieldmann FZS 2002-E: 6. ASSEMBLY INSTRUCTIONS

Assembly instructions

6. ASSEMBLY INSTRUCTIONS

For Your Safety

WARNING! Prior to any adjustments, disconnect the plug from the power supply source.

Select the appropriate operation position (Fig. 2)

You can select one out of three operation positions (A, B, C):

The operation position A is intended for grass mowing. The wheel assembly can be used at

your discretion.

The operation position B is intended for edge mowing. Use the wheel assembly.

The operation position C is also intended for edge mowing. Do not use the wheel assembly.

Safeguard Attachment (Fig. 3)

Remove two screws (1) from the string trimmer casing (Fig. 3/B).

Place the motor cover so that the string head carrier faces upwards (Fig. 3/A).

Slide the safeguard (2) over the motor cover (Fig. 3/A).

Insert two screws back to the trimmer head through the safeguard openings and tighten

them, see the figure 3/B.

Check the nylon strings (Fig. 4)

Prior to the first startup of the electric string trimmer, check whether the nylon strings touch

the cut-off blade or whether it is by-passed. If the strings are not long enough (1), press the

button (2) and pull out the nylon string to have the sufficient length. (See the figure 4/A)

The extended nylon string will be automatically cut by the cut-off blade to the appropriate

length as soon as you turn the string trimmer on.

The nylon string gets shorter or worn during the string trimmer operation. To extend the nylon

string automatically or to move the string, tap the spool button (3) slightly to the ground (the

string trimmer is ON), see the figure 4/B.

You should repeat the above mentioned steps several times prior to start working with the string

trimmer in order to be sure the trimmer works properly and to get familiarized with the trimmer

control elements. Start off slowly, when you have gained experience, you will be able to use the

string trimmer to its full potential.

Replacement of the Nylon String Spool

Turn the machine upside down.

Press the locking latches on the string head cover, as depicted in figure 5, pull the cover and

remove it.