Yamaha ns-c700: SUPPLIED CONNECTIONS TO YOUR ACCESSORIES AMPLIFIER PLACING THE SPEAKERS

SUPPLIED

CONNECTIONS TO YOUR

ACCESSORIES

AMPLIFIER

Before making connections, make sure that the amplifier is

switched off.

Fastener × 4

Loosen

Tighten

PLACING THE SPEAKERS

Black (–)

Red (+)

Place the speaker on a TV rack or other stable surface. To prevent

the speaker from falling down, attach the fasteners provided in

Bare wire

each corner of the speaker's underside.

Insulation

coating

Front

NS-C700

Subwoofer

NS-C700

CENTER

+

Surround

–

back

Surround

Amplifier or

Receiver

• Connect the screw-type input terminals at the rear of the

speakers to the speaker output terminals of the amplifier (or

receiver) with the speaker cable.

• Connect the (+) terminals on the amplifier (or receiver) to the

(+) terminal of each speaker, making sure to confirm the color-

coded wire of the cable at each end. Use the other wire of the

cable to connect the (–) terminals of the components.

• Connect the speaker to the center terminals of your amplifier,

making sure not to reverse the polarity (+, –). If the speaker is

connected with reversed polarity, the sound will be unnatural

Fastener

and lack bass.

Notes

• Do not touch the adhesive surface after peeling off the seal

as this will weaken its adhesive strength.

• Thoroughly wipe clean the surface where the fasteners are

to be attached. Note that adhesive strength is weakened if

the surface is dirty, oily or wet, and that this may cause the

center speaker to drop.

• Placing this unit too close to a TV set might impair picture

English

color or create a buzzing noise. Should be happen, move the

speaker away (more than 20 cm (7-7/8”)) from the TV set.

• To avoid accidents resulting from tripping over loose

speaker cables, fix them to the floor.

1 En