Yamaha NS-F210: CONNECTIONS TO YOUR AMPLIFIER

■ How to connect

CONNECTIONS TO YOUR

1 Loosen the knob.

AMPLIFIER

2 Remove 10 mm (3/8”) of insulation from each end of the

cables, and twist the exposed conductors together neatly and

Before making connections, make sure that the amplifier is

tightly, as shown below.

switched off.

10 mm

(3/8 ”)

Tighten

Loosen

Red (+)

Good No Good

3 Insert the bare wire.

4 Tighten the knob and secure the cables.

Test the firmness of the connection by pulling lightly on the

cables at the terminal.

Black (–)

Notes

• Do not let the bare speaker wires touch each other as this

could damage the speaker or the amplifier, or both.

• Do not insert the insulation into the hole. Sound may not be

produced.

■ When using a banana plug

Note

NS-F210

NS-F210

Do not take off this cover unless using a banana plug.

SPEAKERS

Banana plug

LR

Speakers

Amplifier or

output

Receiver

A

terminals of

+– –

+

the amplifier

(or receiver)

Cover

B

• Connect the screw-type input terminals at the rear of the

speakers to the speaker output terminals of the amplifier (or

receiver) with the speaker cable.

• Connect the (+) terminals on the amplifier (or receiver) to the

(+) terminal of each speaker, making sure to confirm the color-

coded wire of the cable at each end. Use the other wire of the

cable to connect the (–) terminals of the components.

• Connect one speaker to the left (marked L) terminals of your

1 Remove the cover by pulling it toward you.

amplifier, and another speaker to the right (marked R)

terminals, making sure not to reverse the polarity (+, –). If one

2 Tighten the terminal knob.

speaker is connected with reversed polarity the sound will be

3 Simply insert the banana plug into the terminal.

unnatural and lack bass.

2 En