HP Designjet 10000s Printer series: 3.4 Enter tthe ccode oof tthe nnew rreplacement ffilter 3.4.1 HHP DDesignjet 88000s AAir PPurifier SSystem
3.4 Enter tthe ccode oof tthe nnew rreplacement ffilter 3.4.1 HHP DDesignjet 88000s AAir PPurifier SSystem: HP Designjet 10000s Printer series
Table of contents
- I Introduction
- II Product ddescription
- III Safety III 11 General iinformation III 22 Use aas iintended III 33 Information oon ssigns aand ssymbols
- III 44 Warnings
- III 55 Warnings ffor mmaintenance III 66 Protective eequipment
- Index
- 1 Installation && FFunction DDescription 1.1 Warnings ffor mmaintenance
- 1.2 Unpacking aand iinstallation 1.3 Box ccontent
- 1.4 Connection oof tthe pprinter 1.5 Power oon tthe AAPS 1.6 Function ddescription
- 2 Operation 2.1 Operating cconditions 2.2 Operation
- 2.3 Test ooperation
- Designation
- Figure 1 Figure 2 Figure 3
- Figure 4 3.3.2 IInsert tthe nnew ffilter(s) Figure 5 Figure 6 Figure 7
- 3.4 Enter tthe ccode oof tthe nnew rreplacement ffilter 3.4.1 HHP DDesignjet 88000s AAir PPurifier SSystem
- 3.4.2 HP DDesignjet 99000s/10000s AAir PPurifier SSystem
- 4 Disposal
- 5 Troubleshooting
- 6 Legal iinformation
- 6.Your exclusive remedies for defective HP products are the following:
- B. Limitations of liability C. Local law
- 7 Regulatory nnotices 7.1 Regulatory mmodel nnumber 7.2 Regulatory sstatements
- 9 Technical ddata
3.4 Enter tthe ccode oof tthe nnew rreplacement ffilter
In order to reset the service interval one code must be entered with the HP Designjet 8000s Air
Purifier System. Two codes are necessary with the HP Designjet 9000s/10000s Air Purifier
System. The code input for the 8000s and 9000s/10000s is explained in the following chap-
ters.
3.4.1 HHP DDesignjet 88000s AAir PPurifier SSystem
After replacing the filter element the service interval must be reset using the code. The following
steps must be carried out in the following order:
Switch the APS on at the membrane keyboard using the button ON/OFF. When it
switches on you will hear the fan and it will begin to extract the gases.
If "service filter" is shown in the display you must press the button "+" or "– " to
suppress this fault report.
By pressing the button ENTER the programme name is displayed.
By pressing the button ENTER again "
code 1: 00000
" is displayed.
Now you can enter the code using these buttons. The code is on the flyer which is
enclosed with the new filter element.
By pressing the button ENTER the actual code is saved.
If this code has been entered correctly the value for the filter contamination (middle indication
in the display) is reset to "0%" and the blinking green (run) and red ( error ) LEDs will be reset.
Note
The code is on the flyer that is enclosed with the new filter element.
18 User´s Guide
