HP Designjet 10000s Printer series: 2.3 Test ooperation
2.3 Test ooperation: HP Designjet 10000s Printer series
Table of contents
- I Introduction
- II Product ddescription
- III Safety III 11 General iinformation III 22 Use aas iintended III 33 Information oon ssigns aand ssymbols
- III 44 Warnings
- III 55 Warnings ffor mmaintenance III 66 Protective eequipment
- Index
- 1 Installation && FFunction DDescription 1.1 Warnings ffor mmaintenance
- 1.2 Unpacking aand iinstallation 1.3 Box ccontent
- 1.4 Connection oof tthe pprinter 1.5 Power oon tthe AAPS 1.6 Function ddescription
- 2 Operation 2.1 Operating cconditions 2.2 Operation
- 2.3 Test ooperation
- Designation
- Figure 1 Figure 2 Figure 3
- Figure 4 3.3.2 IInsert tthe nnew ffilter(s) Figure 5 Figure 6 Figure 7
- 3.4 Enter tthe ccode oof tthe nnew rreplacement ffilter 3.4.1 HHP DDesignjet 88000s AAir PPurifier SSystem
- 3.4.2 HP DDesignjet 99000s/10000s AAir PPurifier SSystem
- 4 Disposal
- 5 Troubleshooting
- 6 Legal iinformation
- 6.Your exclusive remedies for defective HP products are the following:
- B. Limitations of liability C. Local law
- 7 Regulatory nnotices 7.1 Regulatory mmodel nnumber 7.2 Regulatory sstatements
- 9 Technical ddata
Button ““+”
This button is used for increasing the fan speed in %-steps. You can notice the
increase in the number of revolutions by the increase in the level of noise. The
changed value will be taken over directly.
Button ““–”
This button is used for reducing fan speed in %-steps. You can notice the reduction
in speed by the reduction in the level of noise. The changed value will be taken
over directly.
LED ““Error” ((red)
If the red LED lights up the filter element is saturated and must be replaced.
LED ““Run” ((green)
Shows that the APS is switched on. If the LED Run blinks green, it means the filter
element must be replaced within 100 additional operating hours.
2.3 Test ooperation
Note
Carry out the test operation if you have just purchased the APS and would like to
become familiar with the functions.
Carry out the test of the APS as follows:
• First check all connections on the APS that they are correct and fitted tightly.
• Switch the APS on via the membrane keyboard using the button ON/OFF.
• Increase the fan speed, by touching the button "+" and keeping it pressed
down. You can notice the increase in the fan speed by the increase in the
level of noise. At the same time, the right % appears in the transparent
display.
• Reduce the fan speed, by touching the button "– " and keeping it pressed
down. You can notice the reduction in speed by the reduction in the level of
noise. In addition to this, the right %-appears in the transparent display
(Minimum 20 %).
• Switch the APS off via the membrane keyboard using the button ON/OFF. If
the APS operates correctly, then the APS is ready for normal operation.
14 User´s Guide
