Gorenje DF 6115 W: Maintenance Charcoal filter (filter version only) Cleaning Replacing lamps Grease filter

Maintenance

Charcoal filter (filter version only)

ATTENTION! Before performing any maintenance operation,

It absorbs unpleasant odours caused by cooking.

isolate the hood from the electrical supply by switching off at

2 charcoal filters are required for cooker hoods with 2 motors

the connector and removing the connector fuse.

and 1 charcoal for cooker hoods with 1 motor.

Or if the appliance has been connected through a plug and

The saturation of the activated charcoal occurs after more or

socket, then the plug must be removed from the socket.

less prolonged use, depending on the type of cooking and the

regularity of cleaning of the grease filter.

Cleaning

In any case it is necessary to replace the cartridge at least

The cooker hood should be cleaned regularly (at least with the

every four mounths.

same frequency with which you carry out maintenance of the

The carbon filter may NOT be washed or regenerated.

fat filters) internally and externally. Clean using the cloth

dampened with neutral liquid detergent. Do not use abrasive

Fig. 10

products. DO NOT USE ALCOHOL!

Place the carbon filter in order to cover the protection grill for

WARNING: Failure to carry out the basic cleaning

the motor fan wheel, then turn the central handle P of the filter

recommendations of the cooker hood and replacement of the

clockwise.

filters may cause fire risks.

To dismount the central handle P of the filter turn the handle

Therefore, we recommend oserving these instructions.

anti-clockwise.

The manufacturer declines all responsibility for any damage to

the motor or any fire damage linked to inappropriate

Replacing lamps

maintenance or failure to observe the above safety

Fig. 11

recommendations.

Disconnect the hood from the electricity.

Cleaning the glass vapour screen (available only in some

Warning! Prior to touching the light bulbs ensure they are

models)

cooled down.

Fig. 12

Access the lamp housing area:

The glass be dismounted and cleaned using a normal glass

remove the lamp holder using a small screwdriver or similar

detergent.

tool as a lever.

Instructions for removing the glass:

Replace the damaged light bulb.

1. Remove the grease filter.

According to the model you have:

2. Lightly push the glass downwards and allow it slide

Use plain candle lamps 40W max (E14) or halogen lamps

forwards.

20W max (G4 12V)

3. Remove the glass allowing it to rotate slightly.

Then close the lamp housing (snap lock).

After cleaning, follow the instructions in reverse to remount the

If the lights do not work, make sure that the lamps are fitted

glass.

properly into their housings before you call for technical

assistance.

Grease filter

This must be cleaned once a month using non aggressive

detergents, either by hand or in the dishwasher, which must

be set to a low temperature and a short cycle. When washed

in a dishwasher, the grease filter may discolour slightly, but

this does not affect its filtering capacity.

To remove the grease filter, pull the spring release handle.

Fig. 9

12