NAD HTR 8: инструкция

®

HTR8

Learning Remote

ENGLISHFRANÇAISESPAÑOLITALIANODEUTSCHNEDERLANDSSVENSKAРУССКИЙ

/

/

/

Owner’s Manual

Manuel d’Installation

Manual del Usuario

Manuale delle Istruzioni

Bedienungsanleitung

Gebruikershandleiding

Bruksanvisning

Инструкция по эксплуатации

HTR8_eng_OM_v03.indd 1 20/01/2012 1:46am

ENGLISH FRANÇAIS ESPAÑOL ITALIANO DEUTSCH NEDERLANDS SVENSKA РУССКИЙ

1

2

3

/

/

/

4

5

1 Top section features ON/OFF, MACRO

and eight DEVICE SELECTOR keys

2 Upper middle section has CHANNEL,

VOLUME, MUTE, navigation and sur-

round keys

3 Middle section with A/V PSET,

SPEAKER, PROGRAM, CLEAR, TEST,

REPEAT and number keys 0 to 10+

4 Lower middle section with transport

control keys

5 Bottom section with CHANNEL

VOLUME trimming keys

NAD is a trademark of NAD Electronics

International, a division of Lenbrook Industries

Limited

Copyright 2012, NAD Electronics International, a

division of Lenbrook Industries Limited

2

HTR8_eng_OM_v03.indd 2 20/01/2012 1:46am

OVERVIEW OF THE HTR 8

• Controls up to 8 devices.

• Learns up to 360 commands.

• Records up to 52 macros with a

ENGLISHFRANÇAISESPAÑOLITALIANODEUTSCHNEDERLANDSSVENSKAРУССКИЙ

maximum of 64 commands each.

• Congurable punch-through.

• Key illumination with programmable

timeout.

• Upgradable.

• Contains pre-programmed library of

NAD remote codes.

The NAD HTR 8 is ready to operate NAD

components right out of the box, but it

is really eight remotes in one. Each of the

8 DEVICE SELECTOR keys at the top of

the handset can call up a new “page” of

remote control codes to be transmitted

by the remaining keys. You may “teach”

codes from any infrared-remote con-

trolled component, regardless of brand,

to any or all of these.

Obviously, the most logical system is

that you teach the codes from your DVD

player to the [DVD] DEVICE SELECTOR

“page,” your television’s codes to the [TV]

“page” and so on, but there is no required

scheme: You may load any commands

to any key on any page (see “LEARNING

CODES FROM OTHER REMOTES” below).

The HTR 8 is already pre-programmed

with a full complement of NAD

receiver commands on its [AMP] DEVICE

SELECTOR page, and as well as with

library commands to operate most

NAD-brand DVD, BD, CD or TUNER com-

ponents on the corresponding DEVICE

SELECTOR “pages”. These default com-

mands are permanent: Even if you teach

the HTR 8 new commands to take their

place, the underlying library commands

remain in place and can easily be recalled

should you add an NAD component to

your system later (see “DELETE MODE”

below).

GETTING FAMILIAR WITH

THE HTR 8

The HTR 8 is divided into two main sec-

tions. Eight DEVICE SELECTOR keys at the

top—[AMP], [DVD,] [TV,] and so on - set

the handset’s remaining keys to a “page”

of commands to control a particular

component. A DEVICE SELECTOR key

determines only what component the

HTR 8 will command; it does not perform

any function on the component. All the

remaining keys are function keys that can

“learn” control codes from virtually any

infrared remote controller, allowing you

to teach the codes of your equipment,

regardless of brand, to the HTR 8.

3

HTR8_eng_OM_v03.indd 3 20/01/2012 1:46am