NAD HTR 8: ENGLISH FRANÇAIS ESPAÑOL ITALIANO DEUTSCH NEDERLANDS SVENSKA РУССКИЙ

SEARCH MODE

ENGLISH FRANÇAIS ESPAÑOL ITALIANO DEUTSCH NEDERLANDS SVENSKA РУССКИЙ

If none of the codes from the table, when

entered, turns on the component, and

if you are quite sure you have followed

the above procedure completely and

carefully, you may want to try the “search”

method as follows:

Enter Library Mode by simultaneously

pressing-and-holding for 3 seconds both

the desired DEVICE SELECTOR key and

the [A/VPSET] key, until the Learn LED

turns green. Now press-and-hold the

HTR 8’s [D] or [F] key; the remote will

step through all the available codes at a

rate of approximately 1 per second.

When the component turns o, immedi-

ately release the cursor key; press [ENTER]

to accept that code-library and exit the

Library Mode. Try a few commands;

should you prove to have stepped past

the needed code-library, re-enter the

Library Mode and use the cursor key to

step back to it.

Note

It is possible that search mode will

nd code-libraries that operate, at

least partially, some other brand

(non-NAD) components. You may

certainly exploit such capabilities

as you nd them. However, since we

can only ensure the completeness or

accuracy of NAD code-libraries, we

cannot support the HTR 8’s operation

with other-brand components.

CHECKING CODE-LIbRARy

NUMbER

You can check the current code-library

on any DEVICE SELECTOR key as follows.

Enter Library Mode by simultaneously

pressing-and-holding for 3 seconds

both the desired component’s DEVICE

SELECTOR key and the [A/V PSET] key,

until the Learn LED turns green. Press the

[DISP] key; the HTR 8 indicates the current

code-library by ashing its [CUSTOM],

[BD], and [MACRO] keys.

For example, to indicate code-library

#501, the HTR 8 will ash [CUSTOM] 5

times, pause, and then ash [MACRO]

once. You might wish to make a note of

your components’ code-library numbers.

12

HTR8_eng_OM_v03.indd 12 20/01/2012 1:46am