Fieldmann FZR 2010-E: 12. MAINTENANCE

Mowing | Maintenance | Cutting blade maintenance

this will prolong the time to automatically reset the safety cut-out. If the problem is repeated,

we recommend increasing the cutting height to reduce the load of the engine.

12. MAINTENANCE

ATTENTION! Before removing the grass catcher box, stop the lawnmower and unplug the

plug of the extension cable from the socket outlet.

Note: In order to ensure long and reliable operation of the lawnmower, carry out the

following maintenance tasks on a regular basis.

Check the machine visually on a regular basis in order to timely detect visible defects such as

loose, displaced or damaged blade and/or damaged or excessively worn-out parts.

Also check regularly whether the protective covers and guards are undamaged and correctly

attached to the lawnmower.

Before using the lawnmower, always carry out any necessary repairs and maintenance.

Should a failure occur, despite regular maintenance, please contact our Customer Service;

the repair should be carried out by our service partner at any Kingclean professional

workshop.

13. CUTTING BLADE MAINTENANCE

(Fig. G)

For this task, we recommend contacting the authorized service centre. List of

these service centres is available at www.fieldmann.cz

ATTENTION! Never carry out any assembly operation or adjustment until the plug of the

extension cable is removed from the socket outlet. Before starting the work, always make

sure that all the controls are in “Off” position and that the plug of the power cord has been

removed from the socket outlet. Exercise extreme caution when handling the cutting blade - in

order to prevent injury, handle the blade while wearing work gloves.

Tilt the mower to the right side in order to check the cutting blade or ventilator for damage. If

you find any damaged part, replace it.

Disassembly and replacement of the cutting blade can be made as follows: Grip the blade

with your hand protected by garden gloves (not part of the supply) and using a handle

(supplied) loosen and remove the bolt (Pos. 1 in Fig. G) and the cutting blade (Pos. 2 in Fig.

G); replace the cutting blade by a new one. Make sure the cutting blade is in a correct position

as shown in Fig. G and then tighten the blade holder bolt.