ABUS TVAC710x0: 6. Notes on using infrared illuminators 7. Maintenance and cleaning 7.1 Maintenance
6. Notes on using infrared illuminators 7. Maintenance and cleaning 7.1 Maintenance: ABUS TVAC710x0
Оглавление
- These user manual contains important information for installation and operation. This should be also noted when this product is passed on to a third party.Therefore look after these operating instructions for future reference!
- User guide
- Introduction
- Icon explanation Important safety advice The following safety information and hazard notes are not only intended to protect your health, but also to protect the device from damage. Please read the following points carefully: Avoid the following adverse conditions during operation:
- General safety information: Safety information
- Warnings Unpacking
- Table of contents
- 1. Intended use 2. Scope of delivery 3. Features and Functions 4. Description of the illuminators
- 5. Mounting / installation Installation example for installing the cable
- 6. Notes on using infrared illuminators 7. Maintenance and cleaning 7.1 Maintenance
- 7.2 Cleaning Wipe the product with a clean, dry cloth. If the device is very dirty, you can moisten the cloth with lukewarm water. 8. Disposal
- 9. Technical data Model
- Model
24
English
6. Notes on using infrared illuminators
Infrared illuminators as a lighting source can only be used together with infrared B/W or day/night cameras.
When IR illuminators are used, there may be a camera focus shift. This can be avoided by the use of IR-corrected lenses.
The range of infrared illuminators depends on the IR sensitivity of the camera model used. The specified ranges of the illuminators
are based on a camera light sensitivity of 0.1 lux.
Objects can appear unusual in IR light. For example, a green field appears dark in daylight (normal light). In infrared light, however,
green light appears almost white.
As for all illumination sources, the infrared illuminators should be installed as near as possible to the area to be monitored. Make
sure that the light direction is adapted to the camera direction and does not dazzle the camera.
Clean the infrared illuminator regularly (at least every three months) since the light strength is reduced by dirt and the lamp cannot
cool so effectively. Do not use any abrasive substances or alcohol for cleaning.
7. Maintenance and cleaning
7.1 Maintenance
Regularly check the product's physical state, e.g. check for damage of the housing.
If you suspect that safe operation cannot be guaranteed anymore, disconnect the product and ensure that it cannot be used by mistake.
You can assume that safe operation is not possible anymore when
the device shows visible damage,
the device does not function anymore
Please note:
The product is absolutely maintenance-free for you. There are no components on the inside of the product to be checked
or services by you, never open it.
