Mitsubishi Motors Diamond Plus 230 SB: English

English

English-3

Tools 2

Language: 

OSM controls menus are available in six languages.

OSM Position: 

You can choose where you would like the OSM controls

menu to appear on your screen. Selecting OSM Position allows you to

manually adjust the OSM controls menu left, right, up or down.

OSM Turn  Off: 

The OSM controls menu will stay on as long as it is in

use. In the OSM Turn Off sub-menu, you can select how long the

monitor waits after the last touch of a button for the OSM controls

menu to disappear. The preset choice is in 5 seconds step between 5–

120 seconds.

OSM Lock Out: 

This control completely locks out access to all OSM

controls functions except Brightness and Contrast. When attempting to

activate OSM controls while in the lock out mode, a screen will appear

indicating that OSM controls are locked out. To activate the OSM Lock

Out function, press SELECT, then press + and hold down

simultaneously. To deactivate the OSM Lock Out, press SELECT, then

press + and hold down simultaneously.

IPM System Off Mode:

Enable: The IPM System works normally and all stages of energy

savings are utilised.

Disable:  The Off Mode of the IPM System is not used.

NOTE:

 For standard systems and graphics boards, keep the factory

setting at ENABLE.

NOTE:

 Don’t keep the monitor on when ‘No Signal’ is applied.

This could cause image burn in on the screen due to the ‘No Signal’

message being displayed.

EdgeLock Control: 

Operating your monitor at a non-standard timing

may cause images to appear darker than normal or have colour

distortion. Use of the EdgeLock control will adjust images to their

normal state.

Hot Key: 

This selection allows you to use 

 / 

 as brightness control

and –/+ as contrast control.

Factory Preset: 

Selecting Factory Preset allows you a reset most

OSM control settings back to the factory settings. A warning statement

will appear to confirm that you do want to reset ALL settings. Individual

settings can be reset by highlighting the control to be reset and

pressing the 

RESET

 button.

Information

Display Mode: 

Indicates the current mode and frequency setting of the

monitor.

Monitor Info:

 Indicates the model and serial numbers of your monitor.

Refresh Notifier: 

A message will advise you if the refresh rate of the

signal being applied to the monitor by the computer is too low. For

further information, please refer to your display card or system manual.

Declaration of the Manufacturer

We hereby certify that the colour monitor

Diamond Plus 230

SB

 is in compliance with

Council Directive 73/23/EEC:

– EN 60950

Council Directive 89/336/EEC:

– EN 55022

– EN 61000-3-2

– EN 61000-3-3

– EN 55024

and marked with

NEC-Mitsubishi Electric Visual

Systems Corporation

4-13-23, Shibaura,

Minato-Ku

Tokyo 108-0023, JAPAN

01_English

08/05/2002, 15:34

3