Ivoclar Vivadent Variolink Esthetic DC: www.ivoclarvivadent.com/ifu

4.1 Conditioning with phosphoric acid gel (optional)

The bond to enamel can be improved by selectively etching the enamel

or by applying the ”etch & rinse“ technique. Unprepared enamel surfaces

must be conditioned with phosphoric acid (e.g. Total Etch). Please

observe the Instructions for Use for the phosphoric acid gel.

a) Selective enamel etching

Apply phosphoric acid gel (e.g. Total Etch) onto the enamel and allow

it to react for 15-30 s. Then rinse thoroughly with a vigorous stream

of water for at least 5 s and dry with compressed air until the etched

enamel surfaces appear chalky white.

b) Etch & rinse technique

Apply phosphoric acid gel (e.g. Total Etch) onto the prepared enamel

first, and then to the dentin. The etchant should be left to react on

the enamel for 15-30 s and on the dentin for 10-15 s. Then rinse

thoroughly with a vigorous stream of water for at least 5 s and dry

with compressed air until the etched enamel surfaces appear chalky

white.

4.2 Application of Adhese Universal

– Starting with the enamel, thoroughly coat the tooth surfaces to be

treated with Adhese Universal.

– The adhesive must be scrubbed into the tooth surface for at least 20 s.

This time must not be shortened. Applying the adhesive on the tooth

surface without scrubbing is inadequate.

– Disperse Adhese Universal with oil- and moisture-free compressed air

until a glossy, immobile film layer results.

– Light-cure Adhese Universal for 10 s using a light intensity of

≥500 mW/cm² (e.g. Bluephase® Style).

5 Seating of the restoration

– Variolink Esthetic LC is sensitive to any blue light (operatory light,

ambient light). Therefore, Variolink Esthetic LC should not be

dispensed until right before use. Exposure to intensive light should be

avoided during application.

– Apply Variolink Esthetic LC with the application tip or a brush/

spatula directly to the internal surface of the restoration. The

direct application of Variolink Esthetic to the preparation or cavity

pretreated with adhesive is contraindicated.

– Seat the restoration and fix/hold it in place during excess removal.

– Remove all excess luting material.

a) Wiping technique

Remove excess material immediately with a micro-brush/brush/

foam pellet/dental floss or scaler. Make sure to remove excess

material in time, especially in areas that are difficult to reach

(proximal areas, gingival margins).

b) Circular technique suitable for veneers / inlays / onlays – Light-

curing of excess and subsequent removal

Light-cure excess material with a polymerization light (light intensity

≥ 500mW/cm²; e.g. Bluephase Style) for 2 s at a distance of

10-15 mm by running the light probe along the entire cement line.

www.ivoclarvivadent.com/ifu

употреба, моля, посетете

BG За инструкциите за

композитный цемент светового

отверждения

RU Инструкция по применению

– Стоматологический фиксирующий

PL Instrukcja stosowania

– Cement światłoutwardzalny

Manufacturer

Ivoclar Vivadent AG

FL-9494 Schaan/Liechtenstein

kompositcement

SV Bruksanvisning

– Ljushärdande dentalt

Rx ONLY

Date information prepared:

2014-07-09/Rev. 1

666333/WW